User's Manual

English 7
■ Reorient or relocate the receiving antenna
■ Increase the separation between the equipment and the receiver
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
■ Consult the dealer or an experienced radio/television technician for help
The following information is provided on the device or devices covered in this document in compliance with
FCC regulations:
■ Model numbers: T001 (Motion M1200 Tablet PC), T002 (Motion M1300 Tablet PC), T003 (Motion M1400 Tablet
PC)
■ Company name: Motion Computing, Inc.
■ 9433 Bee Caves Road, Building 1, Suite 250
■ Austin, Texas 78733
■ 512-637-1100
Intentional Emitter per FCC Part 15
Embedded in your Tablet PC are various Radio Frequency (RF) wireless communication devices. It may contain one or
more Radio type devices that operate in the 450-1550 KHz band, as well as devices that operate in the 2.4 or 5.4 GHz
Band. All Radio type devices embedded in your Tablet PC have met all the qualifications for use under FCC
regulations and guidelines.
This equipment complies with FCC Radio Frequency Electromagnetic Signal (RF) exposure limits set forth for an
uncontrolled environment of portable transmission. This product has been evaluated for RF exposure at a distance of 20
cm (8 inches). Operation at a separation distance less than 20 cm (8 inches). from the radiating element to nearby
persons will expose nearby persons to RF levels that exceed the FCC rules for RF exposure
Operation of this wireless communication device is subject to the following two conditions:
■ This device may not cause harmful interference
■ This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Do not attempt to service the wireless communication device built into the Tablet PC yourself. Such action may void the
warranty on the Tablet PC. Contact your Motion Reseller or Motion Computing for information about servicing your wireless
communication device.
NOTE: The Radio Frequency (RF) emitter installed in your Tablet PC must not be located or operated in conjunction with any other
antenna or transmitter.
Modifications
The FCC requires that you be notified that any changes or modifications made to this device that are not expressly
approved by Motion Computing, Inc. may void your authority to operate the equipment.
Cables
Connections made to this Tablet PC, use of shielded cables is recommended, however not required. Shielded cables
reduce the risk of possible interference with other radio communication devices and complies with FCC Rules and
Regulations.
Airline Travel Notice
The FAA requires that you suspend wireless operations before boarding an airplane. These include both
internal and external wireless devices. Internal wireless connections are indicated by the wireless LED on the
Tablet PC front panel (identified by the wireless icon shown here). If the LED is ON or blinking, the wireless
connection is enabled. External wireless devices may be installed in the PCMCIA Card slot or attached to the
Tablet PC and must also be disabled.
IMPORTANT: To disable internal Tablet PC wireless operations, open the Motion Dashboard by pressing Hot Key #1 and under
Wireless, disable any wireless connections (802.11 or internal Bluetooth wireless radios). When internal Tablet PC wireless
operations are disabled, the wireless LED on the Tablet PC front panel is OFF.
To disable external wireless devices installed in the Tablet PC PCMCIA Card slot or attached to the Tablet PC, eject the card or
unplug the external device. To disable external devices via the software, see the instructions that came with the device or contact
the device manufacturer.