User's Manual

English
3
■ Store the pen in the pen bay of the Tablet PC. Carrying it in a pocket, toolbox, or similar receptacle that contains
particles or debris may damage the pen tip or embed particles in it that can damage the Tablet PC display.
Cabling and Power Cord Precautions
■ Power cord sets for use in other countries must meet the requirements of that country. Use the appropriate AC
adapter and power cord for your locale. For information about power cord set requirements, contact the Motion
Reseller from whom you purchased the product, or contact Motion Computing if you purchased the product from us.
■ If no power cord was provided for your Tablet PC or for an accessory, purchase a power cord that is approved for
use in your country and that matches the required voltage / amperage rating of the Tablet PC.
■ If you use an extension cord with your AC adapter, ensure that the total ampere rating of the products plugged into
the extension cord does not exceed the ampere rating of the extension cable.
■ When using your power cord, make sure to position it around objects so it will not be cut or punctured.
Power Adapter Precautions
■ Use only the AC adapter and power cord approved for this Tablet PC or Tablet PC accessory. Use of another type of
AC adapter may risk fire or explosion.
■ Place the AC adapter in a ventilated area, such as on a desktop or the floor, when you use it to run the Tablet PC or
to charge the battery. Do not cover the AC adapter with papers or other items that will reduce cooling; also, do not
use the AC adapter while it is inside a carrying case.
■ Be sure that nothing rests on the AC adapter's power cable and that the cable is not located where it can be tripped
over or stepped on.
■ When using your power cord, make sure to position it around objects so it will not be cut or punctured.
■ Disconnect power cords and cables by grasping the connector, not by pulling on the cable itself. As you pull out the
connector, keep it evenly aligned to avoid bending any connector pins. Before you connect a cable, make sure both
connectors are correctly aligned.
Battery Warnings and Precautions
■ The Tablet PC contains an internal lithium ion (Li-ion) battery pack. Replace the internal battery pack only with a
Motion battery or a Motion-approved equivalent to avoid the risk of fire or explosion resulting in personal injury.
■ If you use an external battery pack to power your Tablet PC, be sure you use only a Motion-recommended third-
party product, which has been tested with the Motion Tablet PC, Using a non-Motion-recommended external battery
may cause the Tablet PC to overheat, emit smoke, burst and/or ignite and cause personal injury or damage to the
unit.
■ Do not use the battery pack in combination with other types of battery packs (such as dry-cell battery packs) or
battery packs with different capacities or brands. This can result in it being over discharged during use or
overcharged during recharging, possibly leading it to leak acid, overheat, emit smoke, burst and/or ignite.
■ Do not dispose of batteries in a fire. They may explode. Dispose of used batteries according to the manufacturer's
instructions. The label on the battery lists the manufacturer’s name. See the section “Battery Pack Disposal” in the
Guide for more information about battery disposal.
■ Do not use nor leave the battery pack near a heat source. Heat can melt the insulation and damage other safety
features, possibly leading it to leak acid, overheat, emit smoke, burst and/or ignite.
■ Do not immerse the battery pack in water nor allow it to get wet. Its protective features can be damaged, it can be
charged with extremely high current and voltage, abnormal chemical reactions may occur, possibly leading it to leak
acid, overheat, emit smoke, burst and/or ignite.
■ Do not disassemble or modify the battery pack. If disassembled, the battery pack could leak acid, overheat, emit
smoke, burst and/or ignite.
■ Do not connect the positive (+) and negative (-) terminals with a metal object such as wire. Short-circuiting may
occur leading the battery pack to leak acid, overheat, emit smoke, burst and/or ignite.
■ Do not pierce the battery pack with a sharp object, strike it with a hammer, step on it, or throw it. These actions
could damage or deform it, internal short-circuiting can occur, possibly leading it to leak acid, overheat, emit smoke,
burst and/or ignite.
■ Do not use an apparently deformed or damaged battery pack, which may leak acid, overheat, emit smoke, burst
and/or ignite.
■ Do not directly solder the battery pack. Heat can melt the insulation and damage other safety features, possibly
leading it to leak acid, overheat, emit smoke, burst and/or ignite.