User's Manual
Table Of Contents
- Safety and Regulatory Guide
- Product Safety Information
- Basic Personal Safety Precautions
- Set Up Precautions
- Tablet PC Precautions
- High Risk and Dangerous Activity Warning
- Cabling and Power Cord Precautions
- Power Adapter Precautions
- Battery Pack Warnings and Precautions
- Battery Charger Precautions
- Battery Pack Disposal
- Travel Precautions
- Internal Modem Precautions
- Component Replacement Precautions
- Wireless Mini-PCI Devices
- Accessory Precautions
- Motion-Recommended Third-Party Accessories
- Comfort and Health
- Regulatory and Safety Compliance
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment also complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment, under 47 CFR 2.1093 paragraph (d)(2), which
addresses RF Exposure from radio frequency devices. Operation is within
5.15GHz ~ 5.25GHz frequency range. This frequency range may limit or
restrict the effective use of this equipment to an indoor environment. This
radiated output power is far below the FCC RF exposure limits. Nevertheless,
this device should be used in such a manner that the potential for human
contact during normal operation is minimized. This equipment contains an
internal antenna transmitter whose effective use may be affected if it is co-
located or operating in conjunction with any other antenna or transmitter.
WIRELESS MINI-PCI INSTALLATION
CAUTION: Follow the steps in this procedure carefully. Failure to do so may result
in improper installation that may damage the equipment and void the warranty.
Be sure to install only Motion-recommended wireless mini-PCI devices. Failure to
do so may damage the equipment and void the warranty. Contact Motion
Computing or your authorized Motion reseller for information about Motion-
recommended wireless mini-PCI devices.
WARNING: To avoid the risk of personal injury or damage to the Tablet PC, when
performing the following tasks, turn off your Tablet PC, unplug the AC power
connection, and remove the battery. Ground yourself by touching a grounded
conductive surface, such as a device or appliance with a grounded, three-pronged
plug. Avoid touching the pins and leads on the memory module and the internal
circuitry of the Tablet PC.
1. Disconnect the Tablet PC from AC power and
remove the battery.
2. Remove the two small Phillips head screws securing
the L-shaped cover from the bottom of the Tablet
PC.
3. (To remove an existing wireless card from the slot)
Release the two clips on each side of the card.
When the card pops up, gently pull it from the mini-
PCI slot.
4. Align the edge connectors on the mini-PCI card with
the mini-PCI socket on the Tablet PC.
22