User's Manual
Table Of Contents
- Safety and Regulatory Guide
- Product Safety Information
- Basic Personal Safety Precautions
- Set Up Precautions
- Tablet PC Precautions
- High Risk and Dangerous Activity Warning
- Cabling and Power Cord Precautions
- Power Adapter Precautions
- Battery Pack Warnings and Precautions
- Battery Charger Precautions
- Battery Pack Disposal
- Travel Precautions
- Internal Modem Precautions
- Component Replacement Precautions
- Wireless Mini-PCI Devices
- Accessory Precautions
- Motion-Recommended Third-Party Accessories
- Comfort and Health
- Regulatory and Safety Compliance
devices have an FCC logo (shown here) or FCC ID on the label. Class A devices do
not have an FCC ID on the label. Once you determine the class of the device, refer
to the following corresponding statement and to the FCC notices in this Safety and
Regulatory Guide.
■ Class A is for business or industrial environments.
■ Class B is for residential environments.
This device complies with Part 15 of the Federal Communications Commission
(FCC) Rules. Operation is subject to the following two conditions:
■ This device may not cause harmful interference.
■ This device must accept any interference received, including interference that
may cause undesired operation.
Class A Equipment: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the manufacturer’s instruction manual, may cause interference
with radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case you will be required to correct
the interference at your own expense.
Class B Equipment: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the manufacturer’s instruction manual, may cause interference
with radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, you are encouraged to try to correct the interference by one or
more of the following measures:
■ Reorient or relocate the receiving antenna
■ Increase the separation between the equipment and the receiver
■ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
■ Consult the dealer or an experienced radio/television technician
for help
1
0