User's Manual

English 9
case of absence of information to transmit, or operational
failure. Note that this is not intended to prohibit
transmission of control or signaling information or the use
of repetitive codes where required by the technology.
The device for the band 5150 - 5250 MHz is only for indoor
usage to reduce potential for harmful interference to co-
channel mobile satellite systems; the maximum antenna
gain permitted (for devices in the bands 52250 - 5350 MHz
and 5470 - 5725 MHz) to comply with the e.i.r.p. limit; and
The maximum antenna
gain permitted (for devices in the
band 5725 - 5850 MHz) to comply with the e.i.r.p. limits
specied for point-to-point and non point-to-point
operation as appropriate, as stated in section A9.2(3). In
addition, High-power radars are allocated as primary users
(meaning they have priority) of the band 5250 - 5350 MHz
and this radar could cause interference and/or damage to
LE-LAN devices.
This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or
trans
mitter.
The County Code Selection feature is disabled for products
marketed in the US/Canada. For produc
t available in the
USA/ Canada markets, only channel 1~11 can be operated.
Selection of other channels is not possible.
IMPORTANT NOTE:
IC Radiation Exposure Statement
This equipment was tested for Specic Absorption Rate
(SAR) in a body-worn or portable usage conguration to
the RSS-102 standard. The equipment was tested in
accordance to the measurement methods and procedures
specied in IEEE 1528..
All users of this equipment will
not be exposed to harmful
radio frequencies. Motion has ensured user safety by
limiting the scree
n rotation to maintain a minimal
separation distance of 20cm between the radiating
antenna and the human body. Nevertheless, this device
should be used in such a manner that the potential for
human contact during normal operation is minimized. This
equipment contains an internal antenna transmitter whose
eective use may be aected if it is co-located or operating
in conjunction with any other antennas or transmitters.
This equipment s
hould be installed and operated
with
minimum distance 1.5 cm between the radiator & your
body.
Conformité Européne (CE) European Union
Note: The Motion Tablet PC model CFT-003 is a Class 2
device and is approved for use in the following countries:
L'utilisation de cet equipement (2.4GHz wireless LAN) est
soumise à certaines restrictions: cet equipement peut être
utilisé à l'interieur d'un batiment en utilisant toutes les
frequences de 2400 a 2483.5MHz (Chaine 1–13).
Pour une utilisation en environement exterieur, les
frequences comprises entre 2400-2454 MHz peuvent
être
utilisé. Pour les dernières restrictions, voir http://www.art-
telecom.fr.
For 2.4–GHz wireless LAN operation of this product, certain
restrictions apply. This equipment may use the entire–
2400–MHz to 2483.5–MHz frequency band (channels 1
through 13) for indoor applications. For outdoor use, only
2400-2454 MHz frequency band may be used. For the
latest requirements, see http://www.art-telecom.fr
.
Unintentional Emitter
The (Conformité Européne) symbol found on the
Tablet PC indicates compliance to the EMC Directive and
the Low Voltage Directive of the European Union. This
means that the Tablet PC meets the following technical
standards:
• EN 301-489-1 V1.8.1
• EN 301-489-3 V1.4.1
• EN 301-489-17 V2.1.1
• EN 55022:2006/A1:2007/Class B
• EN 55024:1998/A1:2001/A2:2003
• EN 61000-3-2:2006+A2: 2009
• EN 61000 3-3:2008
• EN 60950-1:2006+A11:2009
Intentional Emitter
The CE mark shown here is a device ID
that means the product complies with the essential
requirements of the R&TTE Directive 1999/5/EC with
essential test suites. Embedded in your Tablet PC are
various Radio Frequency (RF) wireless communication
devices. It may contain one or more Radio type devices
that operate in the 450–600 KHz band, 13.56 MHz as well as
devices that operate in the 2.4 or 5.4 GHz Band, 850 MHz,
1900 MHz, and 2100 MHz. All Radio type devices
embedded in your Tablet PC comply with standards:
• EN62311:2008 / EN62209-2:2010 / EN 62479:2010
• EN300 328 V1.7
.1
• EN 300-330 -2 V1.
5.1
• EN301 893 V1.5.1
AT BE BG CH
CY CZ DE DK
EE ES FI FR
GB GR HU IE
IT IS LI LU
LV MT NL NO
PL RO SE SI
SK TR
0700