Installation Instructions

INSTALLATION
1. Make sure the control box is switched off while connecting all the cables.
2. Use the RG-6 coaxial (long) cable to connect the antenna unit’s DCR-port with
“ANTENNA IN” of the control box. Then use the second coaxial (short) cable to
connect “LOOP-OUT” jack of the control box with the LNB/SAT-IN input of your
satellite receiver. The loop jack passes the complete receiving signal coming from
the satellite to your receiver through or TV set.
3. Connect 12-24 V DC supply voltage to the input of the control box via 5 amp
thermal fuse. The fuse protects it from damages caused by e.g. a shortcut or cable
fire.
IMPORTANT:
Refrain from connecting the control box (+28V) to the antenna unit’s RF-Output using a
coaxial cable. Only use the antenna unit’s DCR-port to connect the control box.
Note:
The antenna unit’s RF-Output can be used for directly connecting an external satellite
receiver.