XM-2DTSB6212 USER MANUAL MIC CAR AUDIO/VIDEO SYSTEM 6.
To ensure safety while driving and to comply with laws, drivers should not watch video or operate the video device while driving.
Content Precaution...................................... 2 Automatic Memory Storing & Safety Information......................... 3 Program Scanning....................... 17 Disc Note....................................... 4 RDS function.................................. 17 Installation .................................... 5 Media Operation............................. 19 Electric Connection ...................... 7 Basic Operation .............................. 20 Remote Control ................
Precaution THANK YOU FOR PURCHASING A SOUNDSTORM MULTIMEDIA PLAYER . Before operating the unit, read this manual thoroughly and keep it handy for future reference . To avoid injury or accident , read the following precautions before installing and operating the unit . ON INSTALLATION DO NOT install any receiver in locations where; - it may obstruct the steering wheel and gearshift lever operations, as this may result in a traffic accident.
Safety Information CAUTION: THIS DIGITAL VIDEO PLAYER IS A CLASS I LASER PRODUCT. HOWEVER THIS DIGITAL VIDEO PLAYER USES A VISIBLE/INVISIBLE LASER BEAM WHICH COULD CAUSE . HAZARDOUS RADIATION EXPOSURE IF DIRECTED. BE SURE TO OPERATE THE DIGITAL VIDEO PLAYER CORRECTLY AS INSTRUCTED. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.
Disc Note Disc formats supported by this player Digital Digital Video Video Audio and Video Disc size 12 cm VCD VCD Audio and Video Disc size 12 cm CD CD Audio Disc size 12 cm MP3 MP3 Audio Disc size 12 cm Discs which cannot be played with this player Digital Video-RAM CDV CDG Handling and Cleaning Dirt, dust, scratches and warping disc will cause misoperation. Do not place stickers or make scratches on discs. Do not warp discs.
Installation NOTES: 1. Choose the mounting location where the unit will not interfere with the normal driving function of the driver. 2. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. 3. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. 4.
Installation DASH BOARD HEX NUT METAL MOUNTING STRAP SPRING WASHER PLAIN WASHER CONSOLE TAPPING SCREW HEX BOLT MOUNTING BRACKET MOUNTING BOLTS MOUNTING BRACKET NOTE: Don`t attempt install the set by yourself, it should be installed by professional installer .
Electric Connection WIRING CONNECTION V-IN V-OUT 2 V-OUT 1 AUX-L RL FL AUX-R RR FR RADIO ANTENNA JACK KEY I INPUT BROWN KEY 2 INPUT WHITE KEY GROUND BLACK ISO CONNECTOR SUBWOOFER GREY REAR CAMERA INPUT YELLOW REAR CAMERA SWITCH PINK PARKING BRAKE INPUT(-) LIGHT GREEN FRONT RIGHT RCA OUTPUT SOCKET FRONT LEFT RCA OUTPUTSOCKET VIDEO INPUT SOCKET VIDEO OUTPUT SOCKET LEFT CH IN SOCKET RIGHT CH IN SOCKET VIDEO OUTPUT SOCKET REAR LEFT RCA OUTPUT SOCKET REAR RIGHT RCA OUTPUT SOCKET Note: the ground
Remote Control 1. POWER or MODE BUTTON 1 2 3 5 7 9 11 13 15 MUTE MODE PLAY/PAUSE 20 STOP 21 ANGLE REDIAL MO/ST ZOOM 4 23 PAIR 6 MENU LOUD EQ CLK LO/DX 8 27 OSD 10 25 BAND 29 ENTER TITLE/PBC 12 31 A/PS VOL 24 26 3. HANG UP or REDIAL BUTTON 4. ZOOM BUTTON(for Digital Video model) 5. CALL or PAIR BUTTON 28 6. MENU (for Digital Video model) or SW BUTTON 30 7. >> BUTTON 37 TOP RPT INT 1 2 3 32 6 33 9. < BUTTON 35 10. BAND or OSD BUTTON 14 VOL 22 2.
Remote Control Preparing the Remote Control Inserting the Battery 1.First push to inside as the direction indicated by the arrow (See 1 )And then Remove the battery holder as the direction indicated by the arrow (See 2 ). 2.Replace the battery Set a new battery property with (+)side up as illustrated (See 3 ). 3.Insert the battery holder. Push in the holder to the original position(See 4 ).
Basic Operation Main Menu Operation In many modes, touch the icon or touch the range to enter the main menu, the message like following as below. LANGUAGE ILLUMINATION COLOR CALIBRATION (3) Setup interface 2 ADJUSTABLE ITEMS: GENERAL ANIMATION (2) (1) (4) 1. POWER icon In any modes, touch the POWER icon to switch the unit off . The monitor will draw in automatically . 2 MINUTE KEY BEEP ON DISC ... RADIO ... General setup interface1 GENERAL 2.
Basic Operation FORMAT This player is capable of playing discs recorded in either PAL or NTSC formats. Make the selection based on whether you are connecting the unit to a PAL TV or an NTSC TV. You can also set the unit to AUTO (auto select). The disadvantage to autoselect is that each time you turn the unit on it checks to see what kind of monitor is connected, which causes a small delay and some flickering of the display image which you may find unpleasant.
Basic Operation AUDIO SETUP Touch the audio to turn to audio quality adjustment. VIDEO SETUP COLOR 0 BRIGHTNESS 0 CONTRAST 0 TINT 0 AUDIO BASS TREBLE SUBWOOFER ... EQ USER Video setup interface audio setup interface1 COLOR: -20 to 20 Adjust the color for the picture-lighter or darker. AUDIO LOUDNESS FADER/BALANCE OFF ... BRIGHTNESS: -20 to 20 Adjust if the picture is too bright or too dark. audio setup interface2 CONTRAST: -20 to 20 Adjust the contrast of the bright and dark portion.
Basic Operation CALIBRATION Touch the arrow as show to calibration the display. Reset Factory Settings RESET button is placed on the housing and must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons: A. Initial installation of the unit when all wiring is completed. B. All the function buttons do not operate. C. Error symbol on the display. MIC NOTE: If RESET is selected, all memory data will deleted, please re-adjust .
Control Panel UNIT KEYS 11 9 3 10 6 MIC 5 2 4 7 8 1 1. AUXILIARY INPUT JACK Insert an external device to this AUX jack in order to have audio output of the device through the unit. 2. SEL BUTTON and VOL KNOB In normal mode, the VOL knob is used to increase or decrease the volume. Press the SEL to switch between BASS,TREBLE,BALANCE, FADE,SWF VOL and SWF FRE. After switching on the desired mode above, rotate VOL knob or press VOL+/ VOL- buttons to set it.
Control Panel In media mode, pressing |<< or >>| button can play the previous or next track; continuously and long pressing |<< or >>| button can fast backwards or forwards at the following multiple of normal speed: x2, x4, x8, x20. 6. (PLAY/PAUSE) /CH 1-6 (RADIO PRESET) A) In Disc Playback Mode Touch this button to pause playback, touch again to resume playback. B) In Radio Mode Touch repeatedly to preset station. With this system a total of 30 stations can be stored in the memory.
Touch Screen Operation RADIO OPERATION Briefly touch “ ” to decrease frequency by one step of channel spacing. Listening to Radio Touch the RADIO ICON in home menu to enter the RADIO mode. In radio mode, tap icon that the display turn dark, tap twice turn dark more, tap thrice to turn off the display, and tap anywhere of the display to turn it on again. Automatic Search During Radio mode, touch and hold (for more than 2 seconds ) either “ / ” ICONS to start search for a radio station automatically.
Touch Screen Operation Automatic Memory Storing & Program Scanning Automatic Preset Setup In Radio Mode, touch and keep (for more than 2 ’ S) the screen of “ ” range to active automatic station storage. The radio searches within the current frequency band, e.g. FM 3 , for the stronger signal level until the search cycle has finished . The six strongest stations are then allocated to the corresponding storage locations . Then the station of the first storage location is set .
Touch Screen Operation PI MUTE : the sound of another station is suppressed . Touch the AF section on touch screen or swing and keep the SEL knob in the TA/AF direction for about 2 seconds , the AF function is activated. The AF symbol appears in the display . TA Traffic Announcement (Priority For Traffic Information) When the AF function has been switched on, the radio continuously tests the signal strength of the AF frequency .
Touch Screen Operation Media Operation To skip the next track In audio play mode, the message will display as below : (When Parking Brake is applied .) To skip the previous track Repeat Function Random Function Previous menu Tap to turn to BT PHONE mode. (after pairing and connecting a mobile phone with BT function). In audio play mode, tap icon that the display turn dark,tap twice turn dark more, tap thrice to turn off the display, and tap anywhere of the display to turn it on again.
Touch Screen Operation BASIC OPERATION Note: when the JPEG disc playback, in normal mode, you can use the cursor buttons to rotate the picture . Press UP to invert an image . Press DOWN to mirror an image . Press LEFT to rotate an image to left . Press RIGHT to rotate an image to right . Pause (still picture) Touch the “ ” section on touch screen during playback will stop play temporary, touch it again to return the normal playback .
Touch Screen Operation T 001/004 C 001/001 MENU FOR VCD : Press the INT button on the remote control. It display will following menu as below : SEQ PLAY 00:25:08 INTR O 1 01:03:02 2. Example for VCD/SVCD, when it is on, it will display the information such as: T 001/004 Note: when select the INTRO Mode, this player to start to play the previous 15 seconds part of each track/chapter on disc. (Touch it again to cancel this mode .
Touch Screen Operation FOR VCD (With PBC OFF) : Touch the screen as show or press the GOTO button on remote control; T 001/004 PBC MIX the screen will display the following message : Touch the to select the your adjustment item, then select the item your favour by touching the numberic buttons , then touch the OK button to confirm .
Touch Screen Operation Digital Video Special Function 1. Multi-subtitle Language Function (for Digital Video Only) 3. Multi-Angle Function (for Digital Video Only) During Digital Video playback. Touch the icon on touch screen(or press the SUBT on the remote) . Each time the button is pressed or touch, number of the subtitle language changes in sequential order. During Digital Video playback, touch the icon on the touch screen .
Touch Screen Operation BT Operation 1.
Touch Screen Operation Tap a icon such as to show as follow: : Tap to download the contacts from your phone. CONTACTS : Tap for phone number search. & : For page turning. b. Use the number icons or buttons to input your desired phone number; * When inputting a wrong digit, use c. After finishing inputting, touch to dial out. icon or < button to delete it.
Touch Screen Operation 3 . BT MUSIC 1 ) Touch BT MUSIC in home menu or pressing MODE button can pop up BT MUSIC interface as follows: Mute function Play/Pause the playing To select the Equalizer mode To skip the next track To decrease the volume level To skip the previous track To increase the volume level Tap to turn to BT PHONE mode. Loudness Function (After pairing and connecting a phone with BT function).
Touch Screen Operation AUX Operation On the front panel of this unit, there is an AUX IN jack, follow the diagram below to connect analogue replay devices(only for the Audio connect, if you want to connect the Video, please plug the
Touch Screen Operation AV Operation Please plug the
Touch Screen Operation USB OPERATION Card OPERATION Following the diagram below, connect your USB device to the front panel USB port . If it is properly connected, the device will be mounted and start playing automatically. First, remove the cover. The unit can support playback MP3/WMA/ JPEG/MP4 format which are stored on SD memory cards . First, remove the cover. Please read the following instructions before you start using a memory card .
Touch Screen Operation STEERING WHEEL CONTROL Touch the SWC icon as follow to turn to steering wheel control . Then tap Assign and tap the button 1 and then select the icon as the picture show, the icon show in button 1 position. After selection tap confirm and back to home menu that means select finish. The function of the icons as follow: Touch to begin function save. After selection touch to confirm operation. During setting, touch the turn to home menu.
Parental Control * Parental Control Q: After inserting a Digital Video disc into the disc slot, if a dialogue box pops up and asks you to input a password, what should you do ? A: The playing disc is locked by a rating level of parental control.
Region Code * Region Code If you insert a disc into the disc slot and REGION ERROR is displayed, the car multi-media system can not play the disc. The reason is that the region codes of the car multi-media system and the used disc do not match each other. Appendix: Region code of D igital Video Motion Picture Association of America (MPAA) divided the world into 6 regions, and gave every region a region code for locking and unlocking D igital Video playback.
Specification General Power Supply Requirement..................................................DC 12V Current consumption........................................................10A MAX. Audio Signal Output ............................................................ 2ch&4ch line out Frequency Response................................................... 20 Hz - 20 KHz S/N Ratio ........................................................................... 90 dB (JIS) Wow and Flutter ............................
Troubleshooting Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. SYMPTOM No power CAUSE SOLUTION The car ignition switch is not on The fuse is blown If the power supply is properly connected to the car accessory terminal,switch the ignition key to "ACC" Replace the fuse Presence of disc inside the Remove the disc in the player, then put a new one player.
