Spec Sheet

xoappliance.com | 800.966.8300
XOU30BWDDGO
rough in dimensions
overlay frame dimensions
34 1/4”
(870mm)
ALL XO UNDERCOUNTER
UNITS ARRIVE PRE-WIRED
WITH LOW PROFILE PLUGS
FOR EASY INSTALLATION
NEED MORE SPACE -
CUT INTO AN ADJOINING
CABINET TO REACH AN
OUTLET THERE
7”
(178mm)
4”
(102mm)
30”
(762mm)
CUTAWAY DETAIL
Showing pin in
hole.
WHEN INSTALLING WITH
THE HINGE SIDE NEXT TO A WALL -
LEAVE ADEQUATE SPACE FOR
CABINET HANDLES
DOOR MUST BE ABLE TO OPEN
A MINIMUM OF 90 .
o
90°
Door Swing
Clearance
Gap
WALL
30” COMBO UNIT
DOUBLE DOOR
THE DOOR STOP IS SET AT 110
BUT CAN BE RESET TO 90 OR 140 .
IF THE DOOR CANNOT OPEN FULLY
YOU CANNOT EXTEND THE RACKS.
O
O O
7/16”
(11mm)
9/16”
(14mm)
5/16” Dia.
(8mm)
OUTSIDE
DOOR SIDE
Drill a hole at least 5/16” in diameter and
1” deep into the top and bottom of the
frame in the location shown.
9/16” in from the edge and 7/16” out from
the unfinisihed side facing the door.
TO ACCOMMODATE THE HINGE PINS
ON THE HINGE SIDE OF THE PANEL
2 7/8”
(73mm)
5”
(127mm)
2 7/8”
(73mm)
5”
(127mm)
29 3/4”
(756mm)
to
30” *
3 1/4” (86mm)
5” (127mm)
14 3/4”
3 1/4” (86mm)
5” (127mm)
(762mm)
(375mm)