Installation Guide

ManualsBrandsXmark ManualsElectronicsCommunications Receiver

eLink Area Receiver (Master and Satellite)

INSTALLATION GUIDE

CONTENTS

The eLink Area Receiver extends the eLink system’s capability to monitor and receive Tag

messages such as tamper alarm that may occur in areas not within the detection zone of a

Controller.

The eLink Area Receiver bundle contains:

• 1 eLink Area Receiver Master

• 4 eLink Area Receiver Satellites

COMPONENT CONNECTIONS

Master

Receiver

Satellite

Receiver

5-pin

connector

RJ-45

connector

Two

identical

RJ-45

connectors

Aux.

Output*

GND

RS+

RS-

V+

*Activated in

Alarm condition

Summary of content (5 pages)

PAGE 1
eLink Area Receiver (Master and Satellite) INSTALLATION GUIDE 1 CONTENTS The eLink Area Receiver extends the eLink system’s capability to monitor and receive Tag messages such as tamper alarm that may occur in areas not within the detection zone of a Controller. The eLink Area Receiver bundle contains: • 1 eLink Area Receiver Master • 4 eLink Area Receiver Satellites 2 COMPONENT CONNECTIONS Aux.
PAGE 2
eLINK AREA RECEIVER INSTALLATION GUIDE 3 INSTALLATION MOUNTING INSTRUCTIONS Each Master Receiver supports up to seven Satellite Receivers. The Satellites are connected in a daisy chain via the RJ-45 connectors. 981-000045-000R1.
PAGE 3
eLINK AREA RECEIVER INSTALLATION GUIDE ⇒ Place the Receiver in the approximate location for final use. ⇒ The Receiver is mounted onto a standard single gang electrical box. ⇒ ⇒ ⇒ If the receiver is installed on a conductive surface (metal wall, or wall with metal mesh inside), the antenna should be swiveled away from mounting surface. If the wall is dielectric (plaster), the antenna can be left parallel to the wall, but should point away from the receiver.
PAGE 4
eLINK AREA RECEIVER INSTALLATION GUIDE 4 OPERATION AND INDICATORS Top view of eLink Area Receiver Status LED indicator STATUS LED INDICATOR Type of Receiver Action LED Indicator Master (yellow LED) Power applied, no Network Slow, dim flashing Power applied, Network OK Continuous dim glow RF Event (e.g. Tamper Alarm) Bright flash followed by previous state Power applied, no Network Slow, dim flashing Power applied, Network OK Continuous dim glow RF Event (e.g.
PAGE 5
eLINK AREA RECEIVER INSTALLATION GUIDE TESTING THE RF COVERAGE The eLink Area Receiver can be used together with an RF test tag to test the RF coverage. The Receiver is equipped with an audible piezo beeper, which will respond to valid Test Transponder messages only. When the transmit button is pressed on the RF Test Tag, the Receiver will provide audible feedback as it receives the message from the RF Test Tag.