Operations Manual

EXI HALO Installation & Operation Manual 981-000003-000
EXI Wireless Systems 24 March 2000
Revision 2.0
5.10.1. CONTROLLER CABINET INSTALLATION
Mount the HALO Elevator Controller Cabinet inside the elevator car. A suitable location for mounting the
cabinet would be bolted securely with locking hardware above the ceiling tile of the elevator car, or on top
of the elevator car roof. The cabinet may be mounted in any orientation, depending on what the space
allows. Ensure that the cabinet can be opened easily to allow you to make the various connections
necessary, and to be able to make adjustments to the controls within the Elevator Controller inside the
Cabinet.
Figure 20 - HALO Elevator Controller Installation
Should any extra holes be required to mount the cabinet, ensure that no steel cuttings fall into the cabinet,
as this may cause the system to malfunction. A 120 VAC duplex plug is required in the proximity of the
cabinet so as to be able to supply power to the cabinet.
The RIM is built into the Cabinet. With the assistance of the Elevator Company, the three wires from the
RS 485 side of the RIM should be pulled to the Elevator Control Room, or Penthouse, from which they
Controller
Cabinet
(Bolted on top of
elevator roof
or on ceiling )
Keypad
SRA-E
Antenna
(2)
Antenna
Cable
Keypad
Cable
RX Antenna
Dropped
Ceiling
Audible
Alarm
Module
RS-485 Connection
to Elevator Control
Roomthrough
travel cable