Installation Manual

EXI HALO Installation Manual Rev 2.0

EXI Wireless Systems Inc. Page 15 June, 1999
If HIGH ID > LOW ID, all Tags with digit x equal to or between the 2 numbers are selected
If HIGH ID < LOW ID, all Tags with digit x greater than or equal to LOW are selected
and all Tags with digit x less than or equal to HIGH are selected
If HIGH ID = LOW ID, only Tags with digit x = to HIGH or LOW are selected
3.2. INSTALL RECEIVERS
Figure 9 – HALO Receiver
Receivers are meant for use where only a “TIC” signal needs to be detected. The “Relay” light
comes on to indicate relay activation when a “TIC” is detected. Receivers are not capable of cre-
ating a field of energy using Exciters, as Controllers can, and therefore do not have to be con-
nected to the Exciter Antennae. Install the RX Antenna onto the Receiver, place the Receiver in the
approximate location for final use, connect the power supply and power-up. Adjust the RX An-
tenna orientation for the best reception.
Figure 10 – HALO Receiver Threshold and Operating Voltage Setting
3.3. TESTING TIC ALARM COVERAGE AROUND THE BUILDING
With all devices installed at the location, ensure that a “TIC” can be detected from all remote corners
and locations of the protected area. Also ensure that the overlapping fields of detection from the vari-
ous Controller and Receiver devices are fine-tuned.
"RX" Antenna
12/24 V DC
HALO "Receiver"
R2 RECEIVER
DATA
COMM.
Made in Canada . . with care
12/24 VDC GROUND DATA 0 DATA 1 N/O 1 COM 1 N/C 1 N/O 2 COM 2 N/C 2
1 2 3 4 5 6 7 8 9 10
POWER
RELAY
EXI ELECTRONIC SYSTEMS
Winnipeg, Manitoba [phone]
Made in Canada
PRODUCT
MODEL NO.
SERIAL NO>
ROAM II/TAGRRR
RECEIVER
1119
RECEIVER
ANTENNA
Back ViewFront View
“Threshold”
Switch
12
24