User's Guide
Table Of Contents
- Limited Warranty
- Record of Changes
- FCC Regulations
- Introduction
- Initializing the ECO-Lite System
- ECO-Lite Controller
- Wireless Keypad
- Bypassing / Escorting Patients
- Accepting Alarms
- Password Management
- Operational Mode Change
- System Settings
- Assigning the Keypad to the Controller
- Tamper Alarm
- Wrist Tags
- Power Supply
- Controller Enclosure
- Wireless Keypad Enclosure
EXI ECO-Lite User Manual 980-000004-000
EXI Wireless Systems 8 May 2000
Revision 1.0
6. ECO-Lite Controller
The ECO-Lite has 3 lights to indicate status:
Green Yellow Red
(Standby) (Bypass) (Alarm)
Front View
•
“GREEN LIGHT”
indicates the power is on and the system is on standby.
•
“RED LIGHT”
FLASHING indicates an alarm is in progress (tag detected in range).
•
“YELLOW LIGHT”
&
“RED LIGHT”
alternately FLASHING indicates the system is in
BYPASS Mode.
Back View
Side View
8 Position rotary switch
use to
set the ID address between the
keypad and controller.
Auxiliary Port
: 1 set of N/O & N/C
relay contacts to drive external devices.
(cameras, sounders, magnetic locks)
Potentiometer
used to adjust
the field detection zone (3’-12’)
Maximum: Fully Clockwise
Input power
from
wall mount adapter
24V @ 500mA
Back-up battery switches.
Shipped in OFF position. Turn
both switches ON to activate
back up battery supply.