User's Guide

XT-6000 User Guide
c. Exiting install mode
i. Press and hold ON/OFF button for approx. 5 seconds any time after solid LED
indication from step 2 above
ii. Or wait for timeout of install mode which is 15 minutes from start of solid LED
status
Important notes about the “INSTALL” LED and install mode:
1. “INSTALL” LED is only operational when the unit is put into the ‘install mode’. It does not
provide information during normal operation.
2. The “INSTALL” LED and the install mode do not work during off power reporting periods
(periodic, listen, motion start/motion stop).
3. Install mode will disable normal unit communications with the asset and the server and the
following conditions will exist:
a. No SMS processing.
b. No processing of forward commands from the server to the unit.
c. No LED status function on the “WLAN” or “ASSET” LEDs during install mode.
4. During the install mode testing, the unit will check for the following:
a. AC power is on
b. Unit is communicating with asset
c. Unit has communicated with server
d. Physical connection detected on the 7 pin connector
e. Battery is detected
f. GPS position obtained
g. 2G/3G cellular registration and activation is good
General Notes
LED Blink Rates:
 Slow Blink – once per three second period
 Med Blink – once per second
 Fast Blink – three times per second
ON/OFF Push Button:
 U OFF and not on AC power
o press ON/OFF Push Button to wake unit (1 sec then release)
o unit will wake for 15 minutes before shutting down (no AC)
 Unit ON and not on AC power or Install Mode
o press and hold for > 15 seconds to initialize unit ship mode shut down