User's Guide

ManualsBrandsXirgo Technologies ManualsElectronicsREEFER CONTAINER MONITORING DEVICES

XT-6000 User Guide

Terminology

a) Unit – Xirgo XT-6000

b) Asset – Customer product that the XT-6000 is mounted to.

1. XT-6000 Installation:

a) Install unit bracket

b) Secure unused high voltage communication connector into unit bracket

c) Install unit into bracket

Push unit into bracket

Secure 2 torx screws

Push On/Off Switch

d) Connect antenna wires to unit

e) Connect 3 and 7 pin connectors to unit

f) Bundle the wires by using cable ties and fix to unit

g) Connect unit ribbon harness to controller

Summary of content (7 pages)

PAGE 1
XT-6000 User Guide Terminology a) Unit – Xirgo XT-6000 b) Asset – Customer product that the XT-6000 is mounted to. 1.
PAGE 2
XT-6000 User Guide h) Attach TK bracket to unit i) Fit unit with bracket to TK controller and tighten upper screws j) Connect antenna wires to unit k) Connect Power Cable Harness X1 RED wire to Transformer X1 tap, and X2 BLACK wire (with ground terminal) to Controller Chassis.
PAGE 3
XT-6000 User Guide Test: o) p) q) r) s) t) u) Connect power plug to power source Put unit into install mode (on/off button) – see section below Observe installer LED for green pass – see section below If installer LED fail, refer to trouble shooting guide and fix issue Take unit out of installer mode Close the controller door. Installation is complete. LED Operation 1. GPS LED (Green):  OFF – GPS OFF  Blinking – GPS Lock (position obtained)  ON solid – No GPS Lock 2.
PAGE 4
XT-6000 User Guide c. Exiting install mode i. Press and hold ON/OFF button for approx. 5 seconds any time after solid LED indication from step 2 above ii. Or wait for timeout of install mode which is 15 minutes from start of solid LED status Important notes about the “INSTALL” LED and install mode: 1. “INSTALL” LED is only operational when the unit is put into the ‘install mode’. It does not provide information during normal operation. 2.
PAGE 5
XT-6000 User Guide Regulatory Statements: FCC: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made to this equipment not expressly approved by Xirgo Technology may void the FCC authorization to operate this equipment.
PAGE 6
XT-6000 User Guide included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Cet émetteur radio (identifier le périphérique par numéro de certification, ou le numéro de modèle si Catégorie II) a été approuvé par Industrie Canada pour fonctionner avec les types d'antennes énumérées ci-dessous avec le gain maximal admissible et l'impédance d'antenne requise pour chaque antenne type indiqué.
PAGE 7
XT-6000 User Guide Europe: Hereby, Xirgo Technologies, Inc. declare that Model No. XT-6000 is in compliance with the essential requirements and other relevant provisions of R&TTE Directive 1999/5/EC. The DOC (Declaration of Conformity) can be found at the following link: www.xirgotech.