Product Manual
Table Of Contents
- 1. Functional Description
- 2. Device Setup
- 3. Interfaces
- 4. Device Configuration
- 4.1. APNs (apn)
- 4.2. OBD Accel and Decel (oad)
- 4.3. OBD RPM and Speed Events (ors)
- 4.4. OTA Prevent (ota)
- 4.5. Bluetooth Enabled (blt)
- 4.6. Buzzer Songs (bzr)
- 4.7. Destination (dst)
- 4.8. Generic Config Value (gcv)
- 4.9. Input Default Polarity (idp)
- 4.10. Motion Sensitivity (mst)
- 4.11. Serial Port Settings (sps)
- 4.12. Timer Duration (tmr)
- 4.13. Packet Creation Recipe (pcr)
- 4.14. Third-Party Config Values (tpv)
- 4.15. GPS Solution Filter (gsf)
- 4.16. Vehicle Bus Configuration (vbs)
- 5. Interpreter
- 6. Command Language
XT2500 Product Manual
Page 91 | 92
CONFIDENTIAL AND PROPRIETARY
6.6.20. TPS
Command Function
:ecm Enable TPS debug prints
:dcm Disable TPS debug prints
:wcdm <mask> Set debug mask
:wcsim hdr Write into the TPS simulator header
:wcsim tags <protocol> <link> Write a TPS simulator tag
:rctest vin Check if the current tag VIN matches the vehicle VIN
:rctest file Checks if there is a valid tps file
:rctest hdr Read TPS header
:rctest tag <tag_id>
:qci tag
Read TPS tag info
:rctest data
:qci data
Read TPS tag data
:qci block <bock_id> Read TPS block
:qccmd sync Sync TPS file with AAb3 target servers
:gcfw x <serial_port_id>
"<name>"
Upgrade TPS file via xmodem
6.6.21. Aux Passthru
Command Function
:qvi Print info
:evm Enable aux passthru debug channel monitoring
:dvm Disableaux passthrudebug channel monitoring
:wvdm <mask_base10> Write (configure) aux passthru debug mask
Mask Values:
Value Description
0 None
1 Payload
2 Scratchpad
:rvdm Read (print out) aux passthru debug mask
:xvmsg <bytes> Send a packet to be transmitted out over the aux port
If the <bytes> field begins with "0x", the message is sent in hex;
if the <bytes> field does not begin with "0x", the message is sent in ASCII