Product Manual
Table Of Contents
- 1. Functional Description
- 2. Device Setup
- 3. Interfaces
- 4. Device Configuration
- 4.1. APNs (apn)
- 4.2. OBD Accel and Decel (oad)
- 4.3. OBD RPM and Speed Events (ors)
- 4.4. OTA Prevent (ota)
- 4.5. Bluetooth Enabled (blt)
- 4.6. Buzzer Songs (bzr)
- 4.7. Destination (dst)
- 4.8. Generic Config Value (gcv)
- 4.9. Input Default Polarity (idp)
- 4.10. Motion Sensitivity (mst)
- 4.11. Serial Port Settings (sps)
- 4.12. Timer Duration (tmr)
- 4.13. Packet Creation Recipe (pcr)
- 4.14. Third-Party Config Values (tpv)
- 4.15. GPS Solution Filter (gsf)
- 4.16. Vehicle Bus Configuration (vbs)
- 5. Interpreter
- 6. Command Language
XT2500 Product Manual
Page 72 | 92
CONFIDENTIAL AND PROPRIETARY
5.3.11. OBD Trip Start Reason (Bit Mask)
Value (Hex) Description
0x0001 Detected Alternator On or Switched Ignition Input
0x0002 Detected GPS Movement
0x0004 Detected Vehicle Bus Traffic
0x0008 Detected Changing Vehicle Speed
0x0010 Detected Changing RPM
5.3.12. OBD Trip End Reason (Bit Mask)
Value Description
0x00000001 Start Trip Detect Failed
0x00000002 Protocol detected, but no start trip conditions met
0x00000004 Failed to enable and configureOBD communications to aprevious known protocol
0x00000008 Failed all attempts at vehicle protocol communications
0x00000010 Trip was active; failed tomonitor any valid messagesfor x seconds or failed all requests for
mode 1, pid 0
0x00000020 Master Vehicle Speed ECU has stopped responding
0x0000040 Master RPM ECU has stopped responding
0x0000080 Three-Minute Timer expired with no changing RPM.
0x0000100 ECO mode not enabled and RPM of 0 detected
0x0000200 TPS Filed upload request
0x0000400 CAN Transport is not configured
0x0000800 J1939 No Valid Claim Address
0x0001000 CAN Transport - transmit not ready
0x0002000 CAN Send - CAN Controller not Active
0x0004000 CAN Bus Off
0x0008000 CAN Transmit Timeout
0x0010000 CAN hardware Off
0x0020000 CAN Invalid Transmit Length