Product Manual
Table Of Contents
- 1. Functional Description
- 2. Device Setup
- 3. Interfaces
- 4. Device Configuration
- 4.1. APNs (apn)
- 4.2. OBD Accel and Decel (oad)
- 4.3. OBD RPM and Speed Events (ors)
- 4.4. OTA Prevent (ota)
- 4.5. Bluetooth Enabled (blt)
- 4.6. Buzzer Songs (bzr)
- 4.7. Destination (dst)
- 4.8. Generic Config Value (gcv)
- 4.9. Input Default Polarity (idp)
- 4.10. Motion Sensitivity (mst)
- 4.11. Serial Port Settings (sps)
- 4.12. Timer Duration (tmr)
- 4.13. Packet Creation Recipe (pcr)
- 4.14. Third-Party Config Values (tpv)
- 4.15. GPS Solution Filter (gsf)
- 4.16. Vehicle Bus Configuration (vbs)
- 5. Interpreter
- 6. Command Language
XT2500 Product Manual
Page 71 | 92
CONFIDENTIAL AND PROPRIETARY
5.3.7. OBD Run States Bits
Bit State
0 Engine Running
1 PTO On
2 Moving
3 Ignition On
5.3.8. OBD Comms State
Value Description
0 OBD comms off
1 OBD comms pending (ECU detected, initiating connection)
2 OBD comms connected (waiting for RPM change or vehicle motion)
3 OBD comms active
5.3.9. OBD Backoff Mode
Value Description
0 OBD not in Backoff
1 OBD Backoff Scantool Detect
2 OBD Backoff MIL Detect
3 OBD Backoff MIL Persisted
4 OBD Backoff Protocol Fail Detect
5 OBD Backoff Scantool Detectuntil Ignition Off
5.3.10. OBD Protocol Table
Value (Hex) Description
0x0001 ISO 9141-2 (Keyword Byte 08 08)
0x0002 ISO 9141-2 (Keyword Byte 94 94)
0x0004 ISO14230 (KWP2000) (5-Baud init)
0x0008 ISO14230 (KWP2000) (Fast init)
0x0010 J1850 PWM (typically older Ford vehicles)
0x0020 J1850 VPW (typically older GM vehicles and some older Chrysler and Toyota)
0x0040 J1708/J1587
0x0080 CAN protocol 11-bit CAN ids
0x0100 J1939
0x0200 CAN protocol 29-bit CAN ids