Product Manual
Table Of Contents
- 1. Functional Description
- 2. Device Setup
- 3. Interfaces
- 4. Device Configuration
- 4.1. APNs (apn)
- 4.2. OBD Accel and Decel (oad)
- 4.3. OBD RPM and Speed Events (ors)
- 4.4. OTA Prevent (ota)
- 4.5. Bluetooth Enabled (blt)
- 4.6. Buzzer Songs (bzr)
- 4.7. Destination (dst)
- 4.8. Generic Config Value (gcv)
- 4.9. Input Default Polarity (idp)
- 4.10. Motion Sensitivity (mst)
- 4.11. Serial Port Settings (sps)
- 4.12. Timer Duration (tmr)
- 4.13. Packet Creation Recipe (pcr)
- 4.14. Third-Party Config Values (tpv)
- 4.15. GPS Solution Filter (gsf)
- 4.16. Vehicle Bus Configuration (vbs)
- 5. Interpreter
- 6. Command Language
XT2500 Product Manual
Page 16 | 92
CONFIDENTIAL AND PROPRIETARY
4.10. MOTION SENSITIVITY (MST)
Configuration instances: 1
Command Type Syntax
SET Command
:wycfg mst <motion_sensitivity_value>
Response
:OK
READ Command
:rycfg mst
Response
| mst: motion:<motion_sensitivity_value> (hex_val)
:OK
Parameter Range Description
motion_
sensitivity_
value
1 to 2000 Configure accelerometer motion sensitivity in thousandths of a unit of
gravity.
4.11. SERIAL PORT SETTINGS (SPS)
l sps[0] -> Aux port 0
l sps[1] -> Aux port 1
Configuration instances: 2
Command Type Syntax
SET Command
:wycfg sps[x] <baudrate> <dps_value> <mode_value> <console_print>
Response
:OK
READ Command
:rycfg sps[x]
Response
|sps[x]: baud:<baudrate> (hex_val), dps:<dps_value> (hex_val), mode:<mode_value>
(hex_val), conprt:<console_print> (hex_val)
:OK