Product Manual
Table Of Contents
- 1. Functional Description
- 2. Device Setup
- 3. Interfaces
- 4. Device Configuration
- 4.1. APNs (apn)
- 4.2. OBD Accel and Decel (oad)
- 4.3. OBD RPM and Speed Events (ors)
- 4.4. OTA Prevent (ota)
- 4.5. Bluetooth Enabled (blt)
- 4.6. Buzzer Songs (bzr)
- 4.7. Destination (dst)
- 4.8. Generic Config Value (gcv)
- 4.9. Input Default Polarity (idp)
- 4.10. Motion Sensitivity (mst)
- 4.11. Serial Port Settings (sps)
- 4.12. Timer Duration (tmr)
- 4.13. Packet Creation Recipe (pcr)
- 4.14. Third-Party Config Values (tpv)
- 4.15. GPS Solution Filter (gsf)
- 4.16. Vehicle Bus Configuration (vbs)
- 5. Interpreter
- 6. Command Language
XT2500 Product Manual
Page 10 | 92
CONFIDENTIAL AND PROPRIETARY
4.3. OBD RPM AND SPEED EVENTS (ORS)
Configuration instances: 2
Command Type Syntax
SET Command
:wycfg ors[x] <threshold> <time sec>
Response
:OK
READ Command
:rycfg ors[x]
Response
| ors[x]: thresh:<threshold> (hex_val), time:<time sec> (hex_val)
:OK
Instance Description
ors[0] RPM Threshold
Parameter Range Description
threshold 0 (disable), 100
to 20000
RPM in 1 rpm to exceed
time sec 1 to 60 Time RPM must be greater than threshold to
declare an RPM Exceeded Event
ors[1] Speed Threshold
Parameter Range Description
threshold 0 (disable),
20 to 150
Speed in 1 mph to exceed
Time sec 1 to 60 Time Speed must be greater than threshold to declare
a Speed Exceeded Event