User's Manual

16
This declaration is based upon the compliance of the Intel® PRO/Wireless 5000 LAN Access
Point model WSAP5000, the Intel® PRO/Wireless 5000 LAN Dual Access Point model
WDAP5000, the Intel PRO/Wireless CardBus Adapter model WCB5000, the Intel PRO/Wireless
PCI Adapter model WPCI5000 and the Intel® PRO/Wireless 5000 Mini-PCI Adapter model
WM3A5000 to the above standards. Intel has determined that the models listed have been shown
to comply with the applicable technical standards if no unauthorized change is made in the
equipment and if the equipment is properly maintained and operated.
These units are identical to the units tested and found acceptable with the applicable standards.
Records maintained by Intel continue to reflect that units being produced under this Declaration of
Conformity, within the variation that can be expected due to quantity production and tested on a
statistical basis, continue to comply with the applicable technical standards.
Warning
To comply with the FCC and ANSI C95.1 RF exposure limits, it is recommended for the following
products: Intel WCB5000 PRO/Wireless 5000 LAN CardBus Adapter, Intel PRO/Wireless
5000 LAN Access Point, Intel PRO/Wireless 5000 LAN Dual Access Point, Intel
PRO/Wireless 5000 LAN PCI Adapter and Intel® PRO/Wireless 5000 Mini-PCI Adapter model
WM3A5000. These mobile device uses radio transmissions to operate. Please keep it at least 20
cm from any persons during operation. This Adapter has passed all necessary tests, and FCC
applications are pending to classify the product as a portable device that can be operated in close
proximity to the human body. The adapter is a wireless device with an integrated antenna. To
comply with the FCC and ANSI C95.1 RF exposure limits, when using such a wireless device
inserted into a laptop computer, it is recommended that the antenna should not be positioned
closer than 20 cm (8 inches) from your body or nearby persons. It is recommended that the user
limit exposure time if the antenna is positioned closer than 20 cm (8 inches). Installers and end-
users must follow the installation instructions provided in this user guide.
Radio Frequency Interference Requirements
This device is restricted to indoor use when used over its full frequency bandwidth capabilities
(5.15 to 5.35 GHz) due to its operation in the 5.15 to 5.25 GHz frequency range. FCC requires
this product to be used indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential
for harmful interference to co-channel Mobile Satellite systems. The product can be used
outdoors only if the frequency range is limited to 5.26 to 5.35 GHz. In addition, it should be noted
that high power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85
GHz bands. These radar stations can cause interference with and /or damage this device. See
the Online User's Guide for information on specifying the radio frequency to be used.
FCC Rules and Regulations - Part 15
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference and,
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that