User's Manual

Les présents appareils numériques n'ément pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de Classe B prescrites dans le règlement sur le brouillage
radioélectrique édicté par le Ministère des Communications du Canada.
These devices comply with Class B Limits of Industry Canada. Operation is subject to the
following two conditions:
1. The device may not cause harmful interference, and
2. The device must accept any interference received, including interference that may cause
undesired operation.
These devices are certified to the requirements of ANSI/IEEE C95.1-1992 and RSS-210 for 5
GHz UNII band devices. The use of these devices in a system operating either partially or
completely outdoors may require the user to obtain a license for the system according to the
Canadian regulations. For further information, contact your local Canada Industry office.
Japan Regulatory Notices
TELEC
This equipment has been certified to conform with the technical regulations of the specified radio
equipment under the radio law of Japan. If you open the case to modify the circuit, you may be
punished by law.
This equipment is for indoor use only under the Radio Wave law.
JATE
Refer to the JATE approval number on the equipment.
Intel® PRO/Wireless 2011B LAN Products
Radio Frequency Interference Requirements – USA
This device uses, generates and radiates radio frequency energy. The radio frequency energy
produced by this device is well below the maximum exposure allowed by the Federal
Communications Commission (FCC).
This device complies with the limits for a Class B digital device pursuant to Part 15 subpart C of
the FCC Rules and Regulations. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
The FCC limits are designed to provide reasonable protection against harmful interference when
the equipment is installed and used in accordance with the instruction manual and operated in a
commercial environment. However, there is no guarantee that interference will not occur in a
particular commercial installation, or if operated in a residential area.