User's Manual

o The use of wireless devices on airplanes is governed by the Federal Aviation
Administration (FAA).
o The use of wireless devices in hospitals is restricted to the limits set forth by each
hospital.
• Antenna use: (Excluding the Intel® PRO/Wireless 5000 LAN CardBus Adapter)
o In order to comply with FCC RF exposure limits, low gain integrated antennas
should be located at a minimum distance of 7.9 inches (20 cm) or more from the
body of all persons.
o High-gain, wall-mount, or mast-mount antennas are designed to be
professionally installed and should be located at a minimum distance of 12
inches (30 cm) or more from the body of all persons. Please contact your
professional installer, VAR, or antenna manufacturer for proper installation
requirements.
• Explosive Device Proximity Warning (see below)
• Antenna Warning (see below)
• Use on Aircraft Caution (see below)
• Other Wireless Devices (see below)
• Power Supply (Access Point) (see below)
Explosive Device Proximity Warning
Warning: Do not operate a portable transmitter (such as a wireless network device) near
unshielded blasting caps or in an explosive environment unless the device has been modified to
be qualified for such use.
Antenna Warning (Excluding the Intel® PRO/Wireless 5000 LAN CardBus Adapter)
Warning: To comply with the FCC and ANSI C95.1 RF exposure limits, it is recommended when
using a wireless device with an integrated antenna (whether an Access Point or a PCI or MiniPCI
card installed in a desktop computer), that the antenna should not be positioned closer than 7.9
inches (20 cm) from your body or other persons for extended periods of time while it is
transmitting (or operating). If the antenna is positioned less than 7.9 inches (20 cm) from the user,
it is recommended that the user limit exposure time.
Use On Aircraft Caution
Caution: Regulations of the FCC and FAA prohibit airborne operation of radio-frequency wireless
devices because their signals could interfere with critical aircraft instruments.
Other Wireless Devices
Safety Notices for Other Devices in the Wireless Network: Refer to the documentation
supplied with wireless Ethernet adapters or other devices in the wireless network.
Power Supply (Access Point)
Use manufacturer-provided power supply with output rating 5.0 VDC and 2.5 A.
FCC Regulations
FCC Regulations Part 15 Declaration of Conformity (DoC)