User Manual
Table Of Contents
- Introduction
- Laptop System Requirements
- Hardware Installation
- Windows Installation
- Windows Modem Troubleshooting
- Modem Diagnostics Tool
- Windows NT 4.0 Modem Setup Installation
- Starting the Configuration Utility
- Configuration Menu
- Setting the Profile
- Setting the Mode
- Setting the SSID
- Setting the Transmit Rate
- Enabling Power Save Mode
- Selecting the Ad Hoc Channel
- Encryption Menu
- Disabling Encryption
- Enabling Encryption
- Creating Encryption Keys Using a Passphrase
- Creating Encryption Keys Manually
- Default Key
- Link Menu
- About Menu
- Introduction to Modem AT Commands
- Special Commands
- AT Command Reference
- Modem S-Registers
- Modem Result Codes
- Wireless Ethernet Mini PCI Adapter Specifications
- Technical Support
- Warranty
- FCC Regulations - Part 15 Declaration of Conformity (DoC)
- Canadian Department of Communications Industry Canada (IC) Notice
- European Community - CE Mark Declaration of Conformity
- European Union CTR 21 Compliance
- New Zealand Telepermit Compliance Notes
- Japan Regulatory Notices
Section 1
Hardware Installation
1
Xircom Inc. Mini PCI User’s Guide
SECTION 1
Hardware Installation
This section describes how to install the Wireless Ethernet and Modem Mini PCI adapter into a
PC notebook.
Introduction
•
Embedded Mini PCI adapter
•
The Mini PCI adapter is a non-user upgradeable system board device, and not an add-in card
•
Supports modem speeds up to 56Kbps using the V.90 standard
•
Supports both 10Mbps and 100Mbps Ethernet networks
•
V.90 modem is upgradeable to the V.92 specification
•
Plugs directly into to a connector directly on the PC motherboard
Laptop System Requirements
•
Up to 2 laptop internal antennas
•
AC97 Soft Modem (requires AC97 compliant Mini PCI socket)
•
Operating Systems: Windows 98SE/2000/Me/NT4.0