User Manual
Table Of Contents
- Introduction
- Laptop System Requirements
- Hardware Installation
- Windows Installation
- Windows Modem Troubleshooting
- Modem Diagnostics Tool
- Windows NT 4.0 Modem Setup Installation
- Starting the Configuration Utility
- Configuration Menu
- Setting the Profile
- Setting the Mode
- Setting the SSID
- Setting the Transmit Rate
- Enabling Power Save Mode
- Selecting the Ad Hoc Channel
- Encryption Menu
- Disabling Encryption
- Enabling Encryption
- Creating Encryption Keys Using a Passphrase
- Creating Encryption Keys Manually
- Default Key
- Link Menu
- About Menu
- Introduction to Modem AT Commands
- Special Commands
- AT Command Reference
- Modem S-Registers
- Modem Result Codes
- Wireless Ethernet Mini PCI Adapter Specifications
- Technical Support
- Warranty
- FCC Regulations - Part 15 Declaration of Conformity (DoC)
- Canadian Department of Communications Industry Canada (IC) Notice
- European Community - CE Mark Declaration of Conformity
- European Union CTR 21 Compliance
- New Zealand Telepermit Compliance Notes
- Japan Regulatory Notices
38
Modem AT Commands
Appendix A
Mini PCI User’s Guide Xircom Inc
S37=10
Attempt to connect at 12000bps.
S37=11
Attempt to connect at 14400bps.
S37=12
Attempt to connect at 16800bps.
S37=13
Attempt to connect at 19200bps.
S37=14
Attempt to connect at 21600bps.
S37=15
Attempt to connect at 24000bps.
S37=16
Attempt to connect at 26400bps.
S37=17
Attempt to connect at 28800bps.
S37=18
Attempt to connect at 31000bps.
S37=19
Attempt to connect at 33600bps.
S40 ETC Startup Autorating
S40=0
Start up with normal autorating (default)
S40=1
Start up at initial rate of 4800 or below
S40=2
Start up at initial rate of 9600 or below
S42 Auto Rate
• V.32bis and V.22bis auto rate is disabled. Retrain operation is disabled or enabled in date mode, and
fallback is disabled in data mode.
S42=0
Auto rate disabled.
S42=1
Auto rate enabled (default).
S43 Auto Mode
• V.32bis startup auto mode operation disabled.
S43=0
Auto mode disabled.
S43=1
Auto mode enabled (default).
S46 Data Compression Selection
•
The setting of this register is used to turn data compression on or off. It is set by AT%Cn.
Data compression can only be enabled when the modem is operating in an error-control
(EC) mode using either V.42 LAP-M or MNP protocols.
S46=0
Modem will not attempt negotiation for data compression
S46=2
Modem will negotiate with a remote modem for data compression (default)
S46=136
Same as S46=0
S46=138
Same as S46=2