User's Manual

14D-Link DHA-130 User Manual

Section 2 - Installation

Connecting your devices (cont.)

4. Verify your Ethernet connection

After connecting your hardware, you can check your connection by looking at the LEDs on the Ethernet port. The

orangeLEDwillbelitbriey,thenthegreenLEDshouldlightuptoindicatealinktoyourrouterormodem,orash

to indicate that data is being transferred to or from your router or modem. If the green light is not lit, check to make

sure that the power adapter is plugged in and is receiving power, and that your router or modem is functioning

properly.

5. Inserting the batteries

Remove the battery cover from the handset by sliding the cover downwards. Insert the

batteries in the directions shown by the icons on the handset. Replace the battery cover

and connect the phone to the base station to charge the batteries. You should leave the

phone on the charger for at least 14 hours to fully charge the batteries.

Warning: Only use the included rechargeable batteries or NiMH 750mAh AAA batteries in the

DHA-130 handset. Do not use alkaline or other types of rechargeable batteries, as they

may leak or explode when the DHA-130 handset is placed on the base station to charge.