User's Manual

32
25
n Paging
n Dial Mode
To stop paging, press the key on the base again
or any key on the handset.
You can page the handset from the base unit
making it ring with a special tone. It's useful to
locate a lost handset.
Press the key on the base unit (less than 5
seconds), all the handsets registered to the
base will ring for about 60 seconds.
You can select to change the dial mode by the
following steps:
1. Press the soft key.
2. Press the key repeatedly to choose
, and press the soft key.
3. Use the key to choose , then
press the soft key.
Menu
BS
Settings Select
Dial Mode
Select
4. You can press the key to select the required
dial mode options ( / ) and press the
soft key. A confirm beep will be heard.
Tone Pulse
Save
Note:
If you are not sure which dialing mode to
select, please contact your local service
provider.
Note:
On a long key press, more than or equal to
5 seconds, the base will enter subscription
mode. For details, see page 38.
n BS Settings
Terminate HS
This function allows you to delete a handset
registration from the base.
1. Press soft key to enter .
2. Press the key to choose the
menu. The display shows
" " to prompt you to enter the PIN Code
(The default PIN Code is "0000"). Then press
the soft key.
3. Use the key to select a handset. If you
select the current handset or a non-existent
handset, a warning tone will sound.
4. Press the to confirm, and the
selected handset will behave according to the
Out Of Range condition.
Select BS Settings
Terminate HS
PIN?
OK
Select
Select
soft
soft key
Flash Time
You can select to change the Flash time by the
following steps:
1. Press the soft key to enter .
2. Use the key to choose menu.
Press the soft key.
3. The display shows the current setting. Use the
key to select / , press
soft key.
Select BS Settings
Flash Time
Select
Flash-1 Flash-2 Save