User's Manual

33
24
n HS Name
n Range Alarm
"HS N" is the default name of the handset after
registration of handset. The handset number N=
1 to 5 reflects the handset is the Nth handset,
which is registered to the base. The HS Label is
displayed in the Standby mode. You can modify it
by the following steps:
1. Press the soft key.Menu
2. Press the key repeatedly to choose
, press the soft key.
HS
Settings Select
3. Use the key to choose , then
press the soft key.
4. You can enter the handset name (up to 6
characters) by using the alphanumeric keys
(use the soft key to delete the incorrect
characters), then press the soft key to
confirm and exit. The handset name will be
modified.
HS Name
Select
Erase
Save
A beep will sound when the handset is out of
range of the Base. You are able to select to
enable/disable this audible warning.
1. Press the soft key.
2. Press the key repeatedly to choose
, press the soft key.
Menu
HS
Settings Select
3. Use the key to choose ,
then press the soft key.
4. Use the key to choose ,
then press the soft key.
5. Use the key to choose / to
enable/disable this audible warning, then
press the soft key, you will hear a
confirm beep.
Tone Setup
Select
Range Alarm
Select
On Off
Save
Modify PIN
This function allows you to change the PIN
number of the currently active Base. The default
PIN is 0000.
3. The display shows " ". Enter the current
PIN, then press the key. If the old PIN
code is validated, you will be prompted to
enter a new PIN code. If the old PIN is not
validated, a warning beep will sound and you
will be returned to the menu.
1. Press the soft key to enter .
2. Use the key to choose menu,
press the soft key.
4. Enter the new PIN, press the key. You
will be requested to confirm the PIN code.
Enter the new PIN again then press the
soft key to confirm and exit.
Select BS Settings
Modify PIN
Select
Next
Save
PIN?
Next
Modify PIN
BS Reset
This function allows you to reset the Base
setting to the factory default.
2. Press the key to choose menu,
press the soft key. You will be
prompted to enter the PIN code.
3. Enter the PIN code (the default PIN is 0000),
then press the soft key. If the PIN
code is validated all Base settings will be
returned to the factory default, otherwise
the settings will remain.
After the resetting, the base will be
reset and the handset will return to
Standby mode.
BS Reset
Select
Reset
Result:
1. Press the soft key to enter .Select BS Settings