User's Manual

42
15
n Receiving a Call
When a call is received, t
If the caller can be identified, the caller's
phone number is displayed. If the caller
cannot be identified, only the
displays.
1. To answer the call, press the key. If
you have activated the Auto Answer
function, when the handset is on the
base,simplyliftituptoanswer.
he indicator
on the base will blink. The
information will appear, too.
information If you have a voice
message, the " " and icon
will be show on the LCD.
2. You can speak. To end the call, either
press the key or replace the handset
on the base.
In use
New Call
New Call
MSG WTG ON
Result: After you hang up the call, the LCD
displays the talk time.
Notes
Up
:
You can select the ringer volume during the
incoming call by using the key.
If you want to delete the icon, press the
key in standby mode, then press and
hold the key. (The handset must be
registered to the base.)
If the polyphonic ring tone is set, the ring
tone may continue for 4 seconds after the
caller's hang-up or after the parallel phone
had answered the calling.
4
ghi
TAM Functions
n Announcement
It is necessary to record the announcement which
requests the caller to leave a message when
nobody is at home. The answer and record
message (Announce1) and the answer only
message (Announce2) can be up to 3 minutes
respectively.
Auto-answer Announce1 is a conventional
message requesting you to leave a message. If
you have not record Announce1 before, the unit
will play the default one "
".
Record Announce1
Hello, your call
cannot be taken at the moment, to record
your message, please speak after the tone
2. Press the soft key to choose .
3. Press key again to choose .
4. Press the key repeatedly to choose ,
press the soft key.
5. You can record your announcement after a tone.
Recording will stop automatically after 3
minutes. You can also confirm and end the
recording by pressing the key. During
recording the LCD shows " ".
Select Announce
Select Announce1
Record
Select
OK
Recording...
If you want to change Announce1, do the
following steps to update it:
1. Press the soft key in Standby mode.TAM