User's Manual

43
14
n Making a Call
Making a call
You can enter the desired phone number in
Standby mode, which allows you to make
corrections before dialing. Follow these steps:
1. Enter a telephone number (up to 32 digits).
Check it. You can also use the key to
insert a pause.
Right
1. Pick up the handset and press the key.
3. To end the call, either press the
2. Dial a telephone number.
key
or replace the handset on the base.
Result: The indicator flashes and the
icon appears on the LCD.
In use
Basic Functions
Note:
You can store up to 10 telephone numbers in
memory for automatic dialing.
Note
Redial
:
To make a call to the last number you dialed,
use the feature. For details, see page
18.
Notes
Erase
Erase
:
If you make a mistake while entering a
number, press the soft key to
clear the last digit.
If you press the soft key for more
than 3 seconds, all the digits you have
entered will be cleared and the phone
returns to the Standby mode.
2. When the number appears correctly, press
the key.
Record Announce2
Announce-only Announce2 is an answer-only
message. If you have not record Announce2
before, the unit will play the default one "
".
If you want to change Announce2, do the
following steps to update it:
1. Press the soft key in Standby mode.
2. Press the soft key to choose .
3. Press key repeatedly to choose ,
then press the key to confirm.
4. Press the key repeatedly to choose ,
press the soft key.
5. You can record your message after a tone.
Recording will stop automatically after 3
minutes. You can also confirm and end the
recording by pressing the key. During
recording the LCD shows " ".
Hello,
your call cannot be taken at the moment,
please call back later
TAM
Select Announce
Announce2
Select
Record
Select
OK
Recording...
Use the base to record Announce1
/Announce2
Press and hold the or key on the base unit
until the system announce. Begin speaking after
you hear the beep. Use the key to finish at any
time.