User's Manual

44
13
When you place the handset on the base, it
automatically turns on. To turn the handset
on or off in Standby mode, follow these
steps:
1. ,
press and hold the key until you
switch the display on.
To turn on the handset when it's off
On power up, the
handset will enter subscription mode
and search for a registered base. A
message as shown below will be
displayed to the user, and the Antenna
icon will flash.
Note
Out Of Range
:
If the handset is successful in finding a
base, the handset will enter the Standby
mode, the display will show handset
number or the handset name (if you have
one saved as described on page 24),
antenna icon, battery icon and current
time. If the handset is not successful in
finding a base, the handset will behave
according to the
condition.
n Turning Handset On/Off
2. , keep the key
pressed until the display turns off.
To turn the handset off
Note
YOU SHOULD FULLY
CHARGE THE HANDSET BEFORE USING.
:
Nothing will appear on the LCD when battery
power is very low.
Searching...
Restore Announce1/Announce2
Way 1: Using the menu
1. Press the soft key in Standby mode.
2. Press the soft key to choose .
3. Press soft key to choose or
press the key to choose ,
then press the key to confirm.
4. Press the key repeatedly to choose ,
press the key to confirm.
5. The LCD will show . Press the
key to restore the default Announce1
/Announce2 or press the key to cancel.
TAM
Select Announce
Select Announce1
Down Announce2
Select
Default
Select
Confirm ? Select
Back
Playback Announce1/Announce2
You can playback the current Announce1/2.
Way 1: Using the menu
Way 2: Using the base unit
1. Press the soft key in Standby mode.
2. Press the soft key to choose .
3. Press soft key to choose or
press the key to choose ,
then press the key to confirm.
4. Press the soft key to choose .
5. The current Announce1/2 will be play. During
the process the indicator will blink and
you can use the soft key to stop and exit.
Press the or key on the base unit to
playback the current Announce1/Announce2. Use
the key to end the playing at any time.
TAM
Select Announce
Select Announce1
Down Announce2
Select
Select Playback
In use
Back
Way 2: Using the base unit
Press or key to play Announce1/2, then
press and hold the key to restore it to the
default one, you will hear a confirm tone. The
default Announce1 or Announce2 will be played
back after that.