User's Manual

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Privacy of communications may not be ensured when using this telephone!
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
For base unit it should be installed and operated with minimum distance 20cm between the radiator&
your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CS03:
This product meets the applicable Industry Canada technical specifications. / Le pr sent mat riel est
conforme aux specifications techniques applicables d'Industrie Canada.
IC Warning
éé
RSS(Category I Equipment):
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
Radio apparatus containing digital circuitry which can function separately from the operation of a
transmitter or an associated transmitter, shall comply with ICES-003. In such cases, the labelling
requirements of the applicable RSS apply, rather than the labelling requirements in ICES-003.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil num rique de la classe B est conforme la norme NMB-003 du Canada.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Le pr sent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autoris e aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radio lectrique subi, m me si le brouillage est
susceptible d'en compromettre le fonctionnement
Conform ment la r glementation d'Industrie Canada, le pr sent metteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inf rieur) approuv pour
l' metteur par Industrie Canada. Dans le but de r duire les risques de brouillage radio ectrique
l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la
puissance isotrope rayonn quivalente (p.i.r.e.) ne d asse pas l'intensit essaire
l' ablissement d'une communication satisfaisante.
é
é
éê
éàé éé
éé
ééél
à
ée é ép é néc à
ét
Radio Apparatus Containing Digital Circuits (ICES-003)
éà