User's Manual

48
13
The supplied handset carrying clip allows you to
conveniently carry the handset with you. It clips
easily to your belt, waist band, or shirt pocket.
If you want to remove the carrying clip:
Insertascrewdriveralongtheedgeofoneof
itsarmsandreleasetheclip.Thenliftitoff.
n Using Handset Carrying Clip
The headset jack is located in the left side of the
handset and is 2.5mm standard plug. Simply plug
the headset into this jack and the headset will be
activated.
n Using Headset (optional)
Note:
When the headset is plugged into the headset jack
the microphone on the handset will be deactivated.
Earphone
Microphone
Clip
Headset Jack
Record Announce2
Announce-only Announce2 is an answer-only
message. If you have not record Announce2
before, the unit will play the default one "
".
If you want to change Announce2, do the
following steps to update it:
1. Press the soft key in standby mode.
2. Press the soft key to choose .
3. Press Up key or Down key repeatedly
to choose , then press the
key to confirm.
4. Press Up key or Down key repeatedly to
choose , press the soft key.
5. You can record your message after a tone.
Recording will stop automatically after 3
minutes. You can also confirm and end the
recording by pressing the key. During
recording the LCD shows " ".
Hello,
your call cannot be taken at the moment,
please call back later
TAM
Select Announce
Announce2 Select
Record Select
OK
Recording...
Use the base to record Announce1
/Announce2
Press and hold the or key on the base unit
until the system announce. Begin speaking after
you hear the beep. Use the key to finish at any
time.
Notes
Answer mode Select
:
When recording the announcement, speak
towards the microphone on the base. To get
the best recording result, you had better
keep your mouth 20cm away from the
microphone.
If you record/playback/restore Announce1 or
Announce2, the answer mode (refer to par.
) will be switched to
the corresponding mode automatically.