User's Manual

12
49
n Installing Batteries (continued)
n Charging Handset
3.
To replace the battery
cover, slide the cover up
until it snaps in place.
The batteries need to be replaced
if they do not recover their full
storage capacity after recharging.
When replacing the batteries,
always use good quality Ni-MH
AAA re-chargeable batteries.
Never use other battery.
Notes:
! Important Note YOU SHOULD FULLY
CHARGE THE HANDSET 15
: Before initial operation,
for about hours.
To charge the handset, place it on the base or charger.
Result: When you place the handset on the base or charger, the
handset automatically turns on.
Restore Announce1/Announce2
Way 1: Using the menu
1. Press the soft key in standby mode.
2. Press the soft key to choose .
3. Press soft key to choose or
press the key to choose ,
then press the key to confirm.
4. Press Up key or Down key to choose
, press the key to confirm.
5. The LCD will show . Press the
key to restore the default Announce1
/Announce2 or press the key to cancel.
TAM
Select Announce
Select Announce1
Down Announce2
Select
Default Select
Confirm ? Select
Back
Play Announce1/Announce2
You can play the current Announce1/2.
Way 1: Using the menu
Way 2: Using the base unit
1. Press the soft key in standby mode.
2. Press the soft key to choose .
3. Press soft key to choose or
press the key to choose ,
then press the key to confirm.
4. Press the soft key to choose .
5. The current Announce1/2 will be played. During
the process you can use the soft key to
stop and exit.
In the active mode (all lights on) press the or
key on the base unit to playback the current
Announce1/Announce2. Use the key to end the
playing at any time.
TAM
Select Announce
Select Announce1
Down Announce2
Select
Select Playback
Back
Way 2: Using the base unit
In the active mode (all lights on) press the or
key to play Announce1/2, then press and hold
the key to restore it to the default one, you will
hear a confirm tone. The default Announce1 or
Announce2 will be played back after that.