User's Manual Part 2

42
15
TAM Functions
n Announcement
It is necessary to record the announcement which
requests the caller to leave a message when
nobody is at home. The answer and record
message (Announce1) and the answer only
message (Announce2) can be up to 3 minutes
respectively.
Auto-answer Announce1 is a conventional
message requesting you to leave a message. If
you have not record Announce1 before, the unit
will play the default one "
".
Record Announce1
Hello, your call
cannot be taken at the moment, to record
your message, please speak after the tone
2. Press the soft key to choose .
3. Press key again to choose .
4. Press the key repeatedly to choose ,
press the soft key.
5. You can record your announcement after a tone.
Recording will stop automatically after 3
minutes. You can also confirm and end the
recording by pressing the key. During
recording the LCD shows " ".
Select Announce
Select Announce1
Record
Select
OK
Recording...
If you want to change Announce1, do the
following steps to update it:
1. Press the soft key in Standby mode.TAM
n Muting the Microphone
During a conversation, you can temporarily
switch your phone's microphone off, so that the
other party cannot hear you.
Example: You want to say something to another
person in the room but do not want
the other party to hear you.
To mute your microphone, press the soft
key during the conversation. The " "
appears on the LCD.
Mute
Call Muted
To unmute the microphone, press the soft
key again. You will restore the normal condition.
Mute
n Adjusting Voice Volume
During a conversation, you can use the
key to adjusts the level of the earpiece (or
the handsfree speakerphone one, if activated)
volume from to . The selected volume
will be displayed on the LCD.
V.1 V.5
You can also select the earpiece volume or the
speaker volume by the in Menu
under , as described in page 35.
Audio Setup
HS Settings