User's Manual Part 2
43
14
Record Announce2
Announce-only Announce2 is an answer-only
message. If you have not record Announce2
before, the unit will play the default one "
".
If you want to change Announce2, do the
following steps to update it:
1. Press the soft key in Standby mode.
2. Press the soft key to choose .
3. Press key repeatedly to choose ,
then press the key to confirm.
4. Press the key repeatedly to choose ,
press the soft key.
5. You can record your message after a tone.
Recording will stop automatically after 3
minutes. You can also confirm and end the
recording by pressing the key. During
recording the LCD shows " ".
Hello,
your call cannot be taken at the moment,
please call back later
TAM
Select Announce
Announce2
Select
Record
Select
OK
Recording...
n Receiving a Call
When a call is received, t
If the caller can be identified, the caller's
phone number is displayed. If the caller
cannot be identified, only the
displays.
1. To answer the call, press the key. If
you have activated the Auto Answer
function, when the handset is on the
base, simply lift it up to answer.
he indicator
on the base will blink. The
information will appear, too.
information If you have a voice
message, the " " and icon
will be show on the LCD.
2. You can speak. To end the call, either
press the key or replace the handset
on the base.
In use
New Call
New Call
MSG WTG ON
Result: After you hang up the call, the LCD
displays the call duration.
Notes
Up
:
You can select the ringer volume by using
the key when the phone rings with an
incoming call.
If you want to delete the icon, press the
key in standby mode, then press and hold
the key. After that, press the key to
return to standby mode. (The handset must
be registered to the base.)
If the polyphonic ring tone is set, the ring
tone may continue for 4 seconds after the
caller's hang-up or after the parallel phone
had answered the calling.
4
ghi
Note
Answer mode Select
:
If you record/playback/restore Announce1 or
Announce2, the answer mode (refer to par.
) will be switched to
the corresponding mode automatically.