User's Manual Part 2

12
45
n Message
The feature allows you to leave a message to the
owner who is not at home. When a call is received
in answer-record mode, the machine will play
Announce1, and then performs message
recording. The process is as follows:
After N times ringing, the phone enters answer-
record mode automatically and starts to play
Announce1. The caller can start to record after a
tone.
Play New/Saved Messages
4. The phone will announce "
"or"
. The relevant messages will be
played one by one. During the process the
indicator will blink. You can use the key
to delete the current message or the soft
key to stop the playing and exit.
You have N new
message(s) You have N saved
message(s)"
In
use
Back
1. Press the soft key in Standby mode.
2. Press the key to choose , use
the key to confirm.
3. Press the key again to choose
or press the key to choose
, press the key to confirm.
TAM
Down Message
Select
Select New
MSG Down Saved
MSG Select
If the handset is in power off mode, when you
place the handset on the base, it
automatically turns on. To turn the handset on
or off in Standby mode, follow these steps:
1. , press
and hold the key until you switch the
display on.
To turn on the handset when it's off
On power up, the handset will
enter subscription mode and search for a
registered base. A message as shown
below will be displayed to the user, and the
signal icon will flash.
Note
Out Of Range
:
If the handset is successful in finding a
base, the handset will enter the Standby
mode, the display will show handset
number and the handset name (if you have
one saved as described on page 23), signal
icon, battery icon and current time. If the
handset is not successful in finding a base,
the handset will behave according to the
condition.
n Turning Handset On/Off
2. , keep the key
pressed until the display turns off.
To turn the handset off
Note
YOU SHOULD FULLY
CHARGE THE HANDSET BEFORE USING.
:
Nothing will appear on the LCD when battery
power is very low.
Searching...
Note:
The messages are played through the
handset speakerphone as default. If you
want to switch to handset receiver, press
the key.