User's Manual Part 1

48
9
Answer mode Select
The answering machine operates in two modes,
"answer and record (Announce1)" or "answer
only (Announce2)". Each mode comes with a pre-
set announcement that is played to your callers.
You can choose the desired mode as follows:
1. Press the soft key in Standby mode.
2. Press the key repeatedly to choose
, use the key to confirm.
3. Press the key repeatedly to choose
, press the key.
4. Use the key to choose or
, press the key.
TAM
TAM
Setting Select
ANNC
Select Select
Announce1
Announce2 Select
Notes:
If you choose Announce2, the caller hears
your announcement but will not be able to
leave a message.
The Announce2 is also played when your
answering machine becomes full.
Set the ring delay
The ring delay is the number of rings after the
answering machine takes an incoming call and
plays your announcement. You can select from 2
to 6 rings or Toll Saver mode. If you select
, when there are new messages waiting to
be played back, the answering machine will
respond after 3 rings, otherwise it will respond
after 6 rings.
1. Press the soft key in Standby mode.
2. Press the key repeatedly to choose
, use the key to confirm.
3. Press the key repeatedly to choose
, press the key.
4. Use the key to choose the answer rings (
~ or ), press the
key.
Toll
Saver
TAM
TAM
Setting Select
Set
Ring Select
2
Rings 6 Rings Toll Saver
Select
n Connecting Lines
n Installing Batteries
Slide the battery cover in the direction of the
arrow and pull it out.
Insert new batteries as indicated, matching
correct polarity (+,-).
The rechargeable Ni-MH batteries (AAA size) come with
your phone. Install the battery before using your
phone.
2.
1.
Connect one end of the phone line cord to the phone
line jack of the base, and the other end to a
standard phone wall outlet.
Connect the modular end of the AC power adapter to
the power jack of the base, then plug the AC adapter
into a standard AC wall outlet.
1.
2.
To AC wall outlet
To phone wall
outlet
Note:
Reversing the orientation may
damage the handset.