Installation Instructions

Shenzhen Xingkai Technology Co., Ltd
15
Figure 6.4.3 drop down interface in downlink mode
This rate value setting must be greater than the rate of the network encoder.
It is suggested that 90% of the downlink mode rate should be consistent with the
encoder rate, so that the distance can be the farthest when the image is stable.
Setting too much will affect the distance transmission, the smaller the bit rate,
the farther the transmission distance, but the bandwidth is small, the encoding
rate of transmission is small, and the image quality will be poor.
6.5 "Channel" interface
Figure 6.5.1 "frequency" interface
The baud rate configuration interface is as follows: