Instruction Manual

INSTALLATION INSTRUCTIONS:
CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE
THIS RECEIVER.
1. Make the wiring connection and RF sensor must be stuck inside
canopy.
2. Once the connection has been made, the receiver inserts into the drop
rod hanging bracket. The canopy comes up to cover the receiver and
bracket.
3. To change the batteries is to open the battery housing cover by sliding
out the cover downward to the arrow shown direction while pressing
down the cover with thumb. Holder for transmitter: if desired, install onto
the wall with screws.
4. This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
L’émetteut/récepteur ecempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Dévelopement
économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tour brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
INPUT OUTPUT