User manual

Table Of Contents
_ Connect the recorded sequencer output to some parameters (see above)
_ start the sequencer by hitting the start button.
The sequencer will start outputting trig and value information. To stop it, just hit the stop button.
If you need to reset the sequencer clock, hit the reset button.
The keyboard can perform starting, stopping or resetting operations on the sequencer, once you have
connected the keyboard trig information to the corresponding sequencer trig inputs (see the Keyboard trig
Matrix).
When the sequencer is running, you can alter the speed by turning the inner knob of the sequencer clock.
The outer ring sets the number of steps, from 2 to 128. These two values are displayed in the LED-like
display.
The switch LOOP/1SHOT/REVERSE allows you to select to mode of the sequencer. In the first case, the
sequencer will read the information in the forward mode, looping from the end back to the beginning of the
sequence. In the 1 shot mode, the sequence will be read only once, stopping at the end. To read/play the
sequence yet again, the start button must be used again (or trigged).
In the reverse mode, the sequencer will loop in reverse mode (the sequence will be read backwards)
The switch CONT/KEYB/STEP allows you to select the clock mode: CONT (Continuous) when you need
the sequencer playing continuously, KEYB - changing when a note is pressed on the keyboard or STEP,
changing when the “NEXT” button is pressed.
12.3.5 Using the Sequencer Editor:
The XILS 4 provides a simple mouse editor for the sequencer. Using the old analog push-button method
to enter or modify a sequence can be difficult. That is why this editor was created to help you.
On the left of the screen you will find check buttons. The left ones are for selecting which track will be
changed by the mouse, while the right one are for selecting which tracks are to be displayed.