User's Manual

156 www.xilinx.com PowerPC™ 405 Processor Block Reference Guide
1-800-255-7778 UG018 (v2.0) August 20, 2004
Chapter 3: PowerPC 405 OCM Controller
R
ISOCMBRAMEVENWRITEEN Output
Note: Optional. Used in dual-port BRAM interface designs only.
Write enable to qualify a valid write into a block RAM via a DCR-
based access. This signal enables a write into the 32-bit memory that
contains even instruction words BRAMISOCMRDDBUS[0:31].
For Virtex-II Pro, connect this signal to both the Enable (EN) and
Write (WE) inputs of a dual-port ISBRAM port for power savings.
For Virtex-4, connect this signal to Write (WE) inputs of a dual-port
ISBRAM port and ISOCMDCRBRAMEVENEN to the Enable (EN)
input of the dual-port ISBRAM port.
For single-port ISBRAM implementations, this signal can be left
unconnected.
ISOCMDCRBRAMODDEN
(Virtex-4 only)
Output
Note: Optional. Used in dual-port BRAM interface designs only.
BRAM enable (odd bank) to qualify a valid read or write from a
BRAM via a DCR-based access, in order to access odd instruction
words.
For Virtex-4, connect this signal to the Enable (EN) input of the dual-
port ISBRAM port.
ISOCMDCRBRAMEVENEN
(Virtex-4 only)
Output
Note: Optional. Used in dual-port BRAM interface designs only.
BRAM enable (even bank) to qualify a valid read or write from
BRAM via a DCR-based access, in order to access even instruction
words.
For Virtex-4, connect this signal to the Enable (EN) input of the dual-
port ISBRAM port.
ISOCMDCRBRAMRDSELECT
(Virtex-4 only)
Output
Note: Optional. Used in dual-port BRAM interface designs only.
Since the DCR bus can only access 32-bit data and the ISOCM has a
64-bit data bus, this output signal, driven by the ISOCM controller,
must be used to select between even and odd instruction words
using a multiplexer in the FPGA fabric. At logic 1, it selects the odd
instruction word; at logic 0, it selects the even instruction word.
Table 3-8: ISOCM Output Ports (Continued)
Port Direction Description