Inc. Portable Generator User Manual

Basic Elements 27
Xilinx Blocks
Block Parameters Dialog Box
The Addressable Shift Register Block Parameters Dialog Box can be invoked by
double-clicking the icon in your Simulink model.
Figure 3-2: Addressable Shift Register block parameters dialog box
Parameters specific to the Addressable Shift Register block are:
• Infer Maximum Latency (depth) using Address Port Width: youcan
choose to allow the block to automatically determine the depth or maximum
latency of the shift-register based on the bit-width of the address port.
• Maximum Latency (depth): In the case thaqt the maximum latency is not
inferred(previous option),the maximum latency can beset explicitly. It must be a
positive integer.
• Allow Additional Hardware in Certain Rate-Change Cases: several
rate-change conditions require the use of extra hardware beyond that used by the
IP core to make it compliant with the Simulink simulation output. A rate-change
condition will be detected if theaddress and data rates differ and the addressport
is running at a non-system rate. Choosing this parameter allows additonal
hardware to be used in these cases.
• Use Enable Port: when checked, the optional enable port is activated.
Other parameters used by this block are explained in the Common Parameters section
of the previous chapter.
Xilinx LogiCORE
The block alwaysuses theXilinx LogiCORERam-based ShiftRegister V5.0. Whenthe
Generate Core parameter is checked, the Use Placement Information
parameter provides the option of generating the core as a Relationally Placed Macro
(RPM) or as unplaced logic.
The core datasheet can be found on your local disk at:
%XILINX%\coregen\ip\xilinx\eip1\com\xilinx\ip\baseblox_v5_0\do
c\ram_shift.pdf