Inc. Network Card User Manual

78 www.xilinx.com 1-Gigabit Ethernet MAC v8.5 User Guide
UG144 April 24, 2009
Chapter 8: Configuration and Status
R
-- DISCONTINUED PRODUCT --
Configuration Registers
After a power-up or system reset, the client may reconfigure the core parameters using
their defaults. Configuration changes can be written at any time. Both the receiver and
transmitter logic responds only to configuration changes during inter-frame gaps. The
exceptions to this are the configurable resets that take effect immediately.
Configuration of the GEMAC core is performed through a register bank that is accessed
through the management interface. The configuration registers available in the core are
listed in Table 8-2. As shown, the address has some implicit don’t care bits; any access to an
address in the ranges shown performs a 32-bit read or write from the same configuration
word.
Table 8-2: Configuration Registers
Address Description
0x200-0x23F Receiver Configuration (Word 0)
0x240-0x27F Receiver Configuration (Word 1)
0x280-0x2BF Transmitter Configuration
0x2C0-0x2FF Flow Control Configuration
0x300-0x33F Reserved
0x340-0x37F Management Configuration
0x380-0x383 Unicast Address (Word 0) (if Address Filter is present)
0x384-0x387 Unicast Address (Word 1) (if Address Filter is present)
0x388-0x38B Address Table Configuration (Word 0) (if Address Filter is
present)
0x38C-0x38F Address Table Configuration (Word 1) (if Address Filter is
present)
0x390-0x393 Address Filter Mode (if Address Filter is present)