Inc. Network Card User Manual

76 www.xilinx.com 1-Gigabit Ethernet MAC v8.5 User Guide
UG144 April 24, 2009
Chapter 7: Using the Physical Side Interface
R
-- DISCONTINUED PRODUCT --
Using the MDIO interface
The MDIO interface is accessed through the optional management interface and is
typically connected to the MDIO port of a physical-layer device to access its configuration
and status registers (see “MDIO Interface,” on page 86). The MDIO format is defined in
IEEE 802.3, clause 22.
Connecting the MDIO to an Internally Integrated PHY
The MDIO ports of the GEMAC core can be connected to the MDIO ports of an internally
integrated physical-layer device, such as the MDIO port of the Xilinx Ethernet 1000BASE-
X PCS/PMA or SGMII core. See Chapter 11, “Interfacing to Other Cores” for more
information.
Connecting the MDIO to an External PHY
The MDIO ports of the GEMAC core can be connected to the MDIO of an external
physical-layer device. In this situation, mdio_in, mdio_out, and mdio_tri must be
connected to a tri-state buffer to create a bidirectional wire, mdio. This tri-state buffer can
be either external to the FPGA, or internally integrated by using an IOB IOBUF component
with an appropriate SelectIO
TM
standard for the external PHY (illustrated in Figure 7-11).
Figure 7-11: Creating an External MDIO Interface
OBUF
IOB LOGIC
OPAD
OI
O
I
IO
T
IOPAD
IOB LOGIC
IOBUF
1-Gigabit Ethernet MAC Core
mdc
mdio_tri
mdio_out
mdio_in
MDC
MDIO