Operation Manual

13
Operation
Set operation frequency
Operation methods:
TS step selection
TS step selection can be realized by the BAND buttons and the
operation method is as follows:
Long-press the BAND left or right button for 2s to step up or
down.
Adjust the frequency
1. Short-press the BAND buttons to adjust to the desired
frequency band.
2. Adjust the TS step and then turn the main knob to set the
desired frequency.
Operate the preamplifier
Operation methods:
Long-press the MODE button to turn on/ off the preamplifier.
The logo "P" will appear at the top of the display.
Note:
Turn off the preamplifier to prevent the receiver from overloading
if the external signal is strong or the interference of the environmental
radio wave is great.