Quick Start Guide

1.How to pair the thermostat with Remote Zone Sensors ?

1. Click the '+' button at the top right of the interface in 'Menu' -> 'Sensors'

on the thermostat and tap 'Next'.

2. Remove the rear cover of the sensor.

3. Press and hold the button on the back of the sensor for 3 seconds until the

indicator on the front of the sensor 󽗊ash red.

4. Wait for sensors to pair automatically. When the pairing is successful, the

sensor 󽗊ashes green light for 3 times.

Now you can set the participation period of the sensor.

During this period, the thermostat will calculate the average temperature

of all the sensors in the occupied state as a reference and use it as the

indoor temperature on the main screen.

FAQ

• Sensors

513 29.8/Occupied

My Sensor 24.9/Occupied

• Sensors Pair

Please press and hold the

button on the back of the

sensor for 3 seconds, the

indicator will ﬂash red,

then tap ‘Next’.

Tip: When you change the setting of sensor, the indoor temperature on the

main screen need update in 2 minutes. If there is no one in the room where

the sensor is located, that sensor will not participate in that calculation.