User's Manual
10
Light appears under following condition:
Paperless, paper jam, print head overheat, print head error or other situations.
PAPER Key(Red): Light appears when paperless.
5.3 Setting Printer Mode
80 printer is initially setup with default value. However, the default printer mode
can be reconfigured to satisfy customer’s needs through the DIP switch, which is
located at the bottom of the printer.
The function of DIP switch setting as follows:
Switch
Function
(on)
(off)
1
cutter
No cutter
With cutter
2
Buzzing prompt
Open buzzing prompt
Close buzzing prompt
3
Printing density
High density
Regular density
4
24 bytes mode
No Chinese Character
With Chinese Character
5
Character per line
42
48
6
Select cash box
Open cash box
Close cash box
7-8
Transmission rate(apply for serial interface)( refer to below information)
Transmission rate(bps)-bytes/s
SW-7
SW-8
38400
ON
ON
115200
OFF
ON
9600
ON
OFF
19200
OFF
OFF
5.4 Self-checking
Self-checking can test whether the printer is working well or not, if it can print
The test list correctly, that means the printer is good enough (which is excluding the
problem with the connected interface to PC); otherwise, it needs repair.
Self-checking could print software version number, print density, interface type,
English character and some Chinese characters by order.
Self-checking procedure:Make sure the printer is connected to the