User's Manual

Poor print quality
●Ribbons and labels are not
installed correctly
●Accumulation of dust on the
print head or adhesives
●Printer print density setting is
incorrect
●The print head is damaged
●ribbon and tags do not match
●Reinstall consumable
●clean printer head
●Clean the rubber rollers
●Adjust the printer print density
and print speed
●Print out self-test page to
check whether is printer head
damage or not, if yes, please
replace the printer head
●Replace suitable ribbon and
label paper
●Thickness of the label paper
more than 0.22mm,may cause print
quality is not good enough
●Make sure that printer head seat
frame is completely closed
Paper jump while
printing
●label size is not correct or
incomplete
●After changed the label paper,
no correcting the senor
●Label sensor is covered with
dust cause detect incorrect
●resize and printing
●Using air brush to clean the dust
on the senor
Printer content is lost
on left and right side
●Wrong label size
●Set correct label size
Label paper fold
●print head pressure uneven
●wrong installation of ribbon
●wrong installation on label
●wrong print density
●set correct print density
●adjust suitable label width