User's Manual
Table Of Contents
- I. Instructions
- 1.1. Safety warnings
- 1.2 Precautions
- II. Main features
- III. Instructions on technical specifications
- IV. Installation and operation of the printer
- 4.1 Unsealing of the printer
- 4.2 Connection method of the printer
- 4. 3 Installation of paper rollers
- 4.4 Installation of label paper
- V. Switches, buttons and indicator lights of the
- 5.1 Power switch
- 5.2 Self-check test of the printer
- VI. Cashbox port of the printer
- VII. Printer cleaning
- 7.1 Clean the printer head
- 7.2 Cleaning sensor
- 7.3 Printing rubber roller cleaning
- VIII. Paper jam elimination method
- IX. Malfunction elimination
- 9.1 Indicator light on the control penal fail to w
- 9.2 Indicator light function well, but the printer
- X. Printer driver
- 10.1 Driver installation under Windows
- 10. 2 Direct drive of serial ports
- XI. NFC function
Settings of each DIP switch
Switches
Functions
On
Off
1
Cutter
No cutter
Cutter
2
Voice prompt
Turn on the voice buzzing
Turn off the voice
buzzing
3
Printing density
High density
Normal density
4
24 character mode
No Chinese
With Chinese
5
printed characters of each line
42
48
6
Select the cashbox
Open the cashbox
Close the cashbox
Transmission speed (serial port valid) (refer to the table below)
Transmission Speed (bps)
SW-7
SW-8
38400
ON
ON
115200
OFF
ON
9600
ON
OFF
19200
OFF
OFF
5.2 Self-check test of the printer
Self-check test can detect whether the printer works well. If it can print out self-checking list sample
correctly, it shows that the printer is in good condition except for its connection with the host interface.
Otherwise repairing is needed.
Self-check test will print out the NO. of software version, printing density, interface form, English characters
and part of Chinese characters sequentially.
The operation method of self-check test is: press down the FEED button and turn on the power source of the
printer after connecting the printer to the computer. The printer will begin reset detection. After that, release
the FEED button within 5 seconds, then the printer will begin the self-check test and print out self-checking
list sample.