User's Manual
Table Of Contents
- I. Instructions
- 1.1. Safety warnings
- 1.2 Precautions
- II. Main features
- III. Instructions on technical specifications
- IV. Installation and operation of the printer
- 4.1 Unsealing of the printer
- 4.2 Connection method of the printer
- 4. 3 Installation of paper rollers
- 4.4 Installation of label paper
- V. Switches, buttons and indicator lights of the
- 5.1 Power switch
- 5.2 Self-check test of the printer
- VI. Cashbox port of the printer
- VII. Printer cleaning
- 7.1 Clean the printer head
- 7.2 Cleaning sensor
- 7.3 Printing rubber roller cleaning
- VIII. Paper jam elimination method
- IX. Malfunction elimination
- 9.1 Indicator light on the control penal fail to w
- 9.2 Indicator light function well, but the printer
- X. Printer driver
- 10.1 Driver installation under Windows
- 10. 2 Direct drive of serial ports
- XI. NFC function
4.4 Installation of label paper
The installation method of thermal label paper (MAX8.0 mm) is as follow:
Open the cover and turn the lever
open the front cover of the printer
Make sure the front cover has been opened
correct direction
wrong direction
As is shown in the picture, put label paper roller onto
paper shaft, adjust the washer and make sure the
paper roller on the left; pull out the paper roller
ahead of the front cover.
Close the front cover of the printer, and press
forward gently until a sound of lock is heard.
V. Switches, buttons and indicator lights of the printer
5.1 Power switch
Power switch is used to turn on/off the printer. The power switch of the printer lies on the right side of the
printer. Press the switch for several seconds, the printer will be turned on. When the printer in on, do the
same and it will be off.
Note
Switch can only work when the printer is connected to power source
Set the default value when the ACE V1 printer leaves factory
Settings can be changed to meet the special needs of users.DIP switch on the bottom of the printer is to adjust
the settings of the printer.